95nm + 30' + 15'
The torque setting for the crankshaft pulley bolt on a 2002 Vauxhall Astra 1.6 is typically around 110 Nm (Newton-meters) or 81 lb-ft. It's important to follow a proper tightening sequence and to use a torque wrench for accuracy. Always refer to the vehicle's service manual for specific guidelines, as specifications may vary slightly depending on the engine variant.
420i.
Fn T
The crankshaft bolt torque specification is 240 pounds of pressure. The crankshaft bolts should be torqued in 60 pound intervals.
Fn T
184 foot pounds
There are bolt all over the crank and they have different torque values. Here are a few. Crankshaft main bearing cap bolt - 36.5 - 41 .O in. lbs. Crankshaft pulley bolt - 7.5 - 9.0 in. lbs. Crankshaft timing belt pulley bolt - 47.5- 5 4 . 0 in. lbs.
The Toyota 20R engine crankshaft bolt torque specification is 150 pounds. The crankshaft bolts should be torqued in 50 pound intervals.
To remove the crankshaft pulley on an Opel Astra Ecotec, first, ensure the engine is cool and disconnect the battery. Use a socket to remove the bolt securing the pulley, but you may need to hold the crankshaft in place with a crankshaft holding tool or a flywheel lock. Once the bolt is removed, gently pull the pulley off the crankshaft. If it's stuck, using a harmonic balancer puller can help safely extract it without damage.
70 ft. Lbs.
220 foot pounds and put sealer on the bolt theads to prevent oil from wicking up the threads
The torque specification for the crankshaft bolt on a 2.0 DOHC Chevy Tracker engine is typically around 70-75 ft-lbs (95-102 Nm). It's important to follow the manufacturer's guidelines and use a torque wrench for accuracy. Additionally, ensure that the bolt is properly lubricated, as this can affect the torque reading. Always consult the specific service manual for your vehicle for the most accurate information.