0
What is the clearance for intake and exhaust valves in a 4.3 vortex motor?
Wiki User
∙ 8y ago
The lifters are hydraulic and require no adjustments. If you have valve clatter you have worn valve train parts.
Wiki User
∙ 8y ago
Add your answer:
Earn +20 pts
How do you adjust valves on 5.7 vortec?
There are 2 different types of valves on the 5.7 L vortex engine. Both the exhaust and fuel injection valves can be adjusted by turning the adjustment screws.
Can the valves be adjusted on 1998 454 7.4 vortex?
can the valves be adjusted on a 1998 454 7.4 vortex with the roller lifters
Can you please tell you the changes that would have to be made to switch a vortex 4.3L motor from a 1995 Blazer S-10 to a 1997 Blazer S-10 that had a vortex 4.3L motor. They are both 4-wheel drive.?
CHANGE TH E INTAKE MANIFOLD MAYBE EXHAUST YEARS VARY
Why does your Chevy 350 vortex blow white smoke out of exhaust?
needs overhaul rings ect.
Will Chevy 97 305 vortex truck heads fit on a 93 350 truck motor or will there be any clearance problems with the pistons?
They are basically the same heads, If the 93 350 is a vortex motor.
Is their a way to make a 90 305 none votex intake work on 96 vortex heads?
no!
Where would the CO2 senors be on a Chevy v6 vortex engine?
Probably on the exhaust manifold before catalytic converter
Where is the knock sensor on a 2000 6.0 vortex?
That engine has 2 of them and you have to remove the intake manifold to even see are to get to them.
Will a 1998 vorteX 350 motors' intake manifold fit a older chevrolet 350 motor?
NO, Not even close.
Will a 43 Vortex fit where a regular 43 was?
Yes. The base engine componants are the same. The differences are the intake and fuel delivery.
What does it take to swap a 1995 vortex v-6 into a 1993 C1500 Chevy?
the 95 and the 93 full size pick ups are identical there should be no need to swap parts the 95 vortec from an S-10 will need the entire intake manifold, exhaust, sensors, and wiring harness from the 93 to make it run
1997 silverado vortex 350 engine intake manifold gasket blew water and oil mix ended up being sucked into intake replaced oil plugs oxygen sensors but engine missing at most speeds ran perfect before?
replace intake manifold gaskets, if gaskets have been replaced and intake has been clean oil and plugs have been changed then your problem most likely would be the timing.timing the distibutor on a vortex engine sometimes can be tricky.
