it is the valve which reduce the pressure.
Yes, same basic function.
Some later models, 2001 onwards, don't have an idle control valve. The function is designed into the Electronic Throttle.
A snap throttle valve on a vehicle works by using dual internal valves that give a full on or off operation.
To clean the throttle valve on a 2003 Renault Clio 1.2, first ensure the engine is off and cool. Remove the air intake hose connected to the throttle body, then spray a throttle body cleaner onto a clean cloth or directly onto the throttle valve, being careful not to soak the electrical components. Gently wipe the valve and its surrounding areas to remove carbon buildup, then reassemble the intake hose and start the engine to ensure proper function. Always consult your vehicle's manual for specific instructions and safety precautions.
The Trailblazer has an electronic throttle (drive by wire). There is no IAC valve, it is built into the throttle body. Remove and clean the entire throttle body.
The Trailblazer has an electronic throttle (drive by wire). There is no IAC valve, it is built into the throttle body. Remove and clean the entire throttle body.
the TPS is located directly under the Idle Air control valve (IAC valve) located on the throttle body
For a steam engine, the steam(throttle) valve that sets the engine speed/power is often known as a regulator. k.Shiva
the throttle sensor function is to stabilize the ref of the car engine
To install a throttle positioning valve on a 1997 Cadillac, first disconnect the negative battery terminal and remove any components obstructing access to the throttle body. Remove the old throttle positioning valve by disconnecting the wiring harness and unscrewing it from the throttle body. Install the new valve by reversing the removal process, ensuring all connections are secure. Finally, reconnect the battery and start the engine to check for proper operation.
There is a throttle position sensor mounted to the throttle body. That's the place where the air intake valve sits near the top of the engine. Look for the throttle butterfly valve; on the end of the butterfly valve shaft should be a little sensor with wires connected; that's the throttle position sensor.
The ERG valve is a valve in the turbo/supercharger system that controls boost pressures to the manifold. Normally it is hooked up to the computer system and the throttle body. Sometimes just the throttle body.