0
The area where a valve closes in the combustion chamber of a four-stroke engine is called the valve seat. During a valve job, this seat is ground at a set angle, usually 45 degrees, for a good seal. In a three-angle valve job, additional angles are ground into each side of the seat angle to ease the transition and improve flow.
Add your answer:
Earn +20 pts
What is an angle valve?
The ports of the angle valve ( Inlet and outlet) are oriented at an angle 90 deg.
What is the purpose of using the angle valve?
where the process require the fluide to be leave at right angleto the direction in which it enters at that time we use angle valve
How do you change a angle valve?
By shutting off the water supply prior to this valve of course
Do you need to pull the engine 3.0 6 of a 1994 LeBaron to do a valve job?
No, you do not have to remove the engine to do a valve job.
What is the function of an angle valve?
To regulate the flow of a liquid or gas.
What are the three parts of an angle?
the interoir angle the exterior angle and the full angle
How are Three fourths of a right angle?
Three quarters of a right angle is 67.5 degrees.
What is the name for a three sided shape?
Triangle - Tri means Three and Angle is an angle
AV valve with three flaps?
Bicuspid valve.. a birth defect of the aortic valve.
What is the max chamber size on 601 Chevy heads I am going to put them on a 350 I am trying to unshroud the intakes can I just grind them out to the head gasket line for a 350 head gasket?
Rather than grinding in the combustion chamber, which would lower the compression ratio, I would think there would be more to gain by working in the valve pocket. Especially the short-side radius and the bottom of the valve guide. Also, a good three-angle valve job can improve flow through the head.
What are three types angles?
Right Angle, Acute Angle, and Obtuse Angle
What are the three angles?
Acute angle, right angle and obtuse angle
