0
What else can I help you with?
If you lost engine compression do you need to replace the motor and where can you buy a good running motor in the Detroit area?
loosing compression does not mean you have to get a new motor it can just mean u have a blown head gasket if its an old carIf compression is lost on only a few cylinders, then check the head gaskets. If compression is lost on all cylinders, check for a worn or broken timing chain.
How old is an Evinrude sportsman SN 4416-04104?
The motor is a 1947 2hp. Great little motors. I have two of my own.
What is the gas to oil ratio for a older Johnson 2 hp outboard?
How Old? I have a 1980 2HP Johnson. The Ratio is 50:1
What is the minimum compression ratio for diesel engines?
Around 18:1 will give a running diesel on a engine such as an old perkins 4203
250 yzf WHY IS IT hard to kick start?
If it is new because the bike has full compression if it is old its good because it still has good comperssion
How do you make an older car run smoothly as though it were new?
I don't know how old old is, but a compression check would be a good place to start. If all the compression is the same, start by rebuilding the carb, new plugs and wires and points and condensor in an older distributor. That's all there is.
Can your car overheat due to low compression?
yes. because engine will have a hard time pushing the cylinders and if your fan is attached to the crankshaft(old engines), it will produce less air.
Why doesmy truck turn over but wont start?
It's the same with all vehicle engine starting troubles... the problem is one of the following:* Compression * Fuel * Ignition Use a compression gauge to check the compression.Use starting fluid to see if the engine will start that way.Pull a plug wire, connect it to a spare plug and lay it on a metal surface of the engine then "crank" the engine to see if there is a strong spark, and use a timing light to verify timing.Eliminate whatever ISN't the problem and whatever is left IS the problem.It doesn't matter if the engine is an old 49 Studebaker or a 2009 Lamborghini...If the engine has compression, fuel and a proper ignition supplied at the right timing, the engine MUST run. It's simple physics.
How safe is the 2hp Plunge Router Wood?
All power tools can be dangerous.Routers are certainly no exception.I think Norm from "This Old House" can give you a full rundown on router safety if you search the web for it.
You change the timing belt on a 1999 ford xlt and the truck still won't start?
Check the compression. If compression is down you may have put the timing belt on wrong. If it's down for only one or two cylinders, your engine may have damaged itself when the old timing belt gave out.
Is 22mpg good for an old car?
Considering mine only gets 15mpg, then yes. 22mpg is very good. It also depends on "how old","weight","engine",and "carberator". I hope i helped.
Why doesn't my old truck start?
If it has fuel, compression and a good spark that's delivered at the right time the engine WILL start. Check for fuel delivery, use a little starting fluid. Check for spark, depending on how old the truck is you may need to replace the points, condenser, plugs, rotor and wires. If the truck has an electronic ignition, run a diagnostic code to see if there are any problems with the electronics.
