You need a bearing puller.
With a bearing Puller
Get a manual for this vehicle.
You will need a bearing puller, they are found in a lot of places like your local part store or online. Best bet is to check at the local parts store and specify bearing puller. Once you have taken the tire and rotor off you will need to loosen the nut on the drive axle by heating it up until its red hot and then taking it off the bearing puller will then be used next. You will also need a hammer of some sort.
A bearing puller is a steel tool with a central hub and a threaded bolt hole running through it, containing a large bolt. There are 2-4 arms with clawed ends attached to the hub so they can be placed around a bearing on a shaft. The bolt is then tightened against the shaft, pulling the bearing off.
A bearing puller is a steel tool with a central hub and a threaded bolt hole running through it, containing a large bolt. There are 2-4 arms with clawed ends attached to the hub so they can be placed around a bearing on a shaft. The bolt is then tightened against the shaft, pulling the bearing off.
you do not use a socket you use a wheel bearing puller to remove it from the hub Putting a right size socket into it and hitting it with a hammer can pop the bearing out, but it can also damage it so its advised to get the right tools. size 30 mm for the wheel nut and the bearing puller
Remove the tire and wheel. Remove the and to the axle. Remove the wheel bearing seal, with a seal puller. Remove the wheel bearing. Reverse the process to install the new wheel bearing.
You need to pull the halfshafts, to get to the trans axle. Then pull the transaxle out from under the car and the release bearing is on the transaxle shaft, you'll need to get a bearing puller to get the bearing loose from it's housing.
remove the transmission and u will need a pilot bearing puller with a slide hammer which u can get at any auto-zone on loan.
To retain friction bearings, devices such as bearing retainers, bearing cages, or bearing housings are typically used. These components hold the bearings in place within a machine or mechanical system to prevent them from moving out of position during operation.
The purpose of a cable puller is to allow a system of wires to pull a heavier load. A cable puller will then be used to feed the cable through on this system.