answersLogoWhite

0


Best Answer

You need to check your timing belt if it is not in time it will not start or run for a little then shut off.

User Avatar

Wiki User

13y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: What happens when you turn the car on the motor start shaking then the car cuts off?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

1994 Honda accord 2.2 starts then cuts off won't start again until motor cools down?

Replace your fuel pump relay.


What happens when something cuts your bruise?

you bleed


How potential relay works in refrigeration?

A potential relay operates on the voltage potential created by the induced voltage in the starting winding of the motor. It is an electromagnetic switch whose coil is wired directly in to the motor circuit. When power is applied to the circuit, the motor starts . As the motor attains its running speed the start winding acts as an auto generator and the voltage potential produced energizes the relay coil which cuts out the start capacitor and the start winding . The start winding still acts as an auto generator , however , and continues to produce enough power to keep the relay energized.


When throttling the power cuts out on a pocket rocket motor?

running lean in other words motor isn't getting enough gas


What happens when fuel filter on a 2001 VW Jetta is bad?

Some possiblilities Loss of power Missfire Bad starting Engine cuts out & may or may not re start.


What will happen if excitation of a running synchronous motor suddenly cuts off?

something cool


Why does my Polo start then cuts out?

crankshaft position sensor


What happens if the police catch you with wrist cuts?

They should try and help you.


What happens if you are pinched by a crab?

Minor injuries and cuts, but nothing major


Why does your 1993 Chevy C-1500 truck cuts off after starting?

It cuts off the engine while you start it up.


What happens when the distributor in 1996 Caprice gets wet?

the car cuts off and everything shuts down and u have to wait a few minutes until it drys off and then it will start back up


How do you minimize the starting current of motor?

One method is to use a star delta starting configuration, two more are electronic starting. A variable speed drive and electronic soft start. These two are almost the same except the soft start doesn't have all the bells and whistles that the VFD has. The soft start usually comes with a bypass contactor. Once the motor is up to speed the bypass contactor cuts in and takes the load off of the soft start.