The transmission will fail.
The brake system uses brake fluid and the trans uses trans fluid.
Accidentally pouring transmission fluid into the brake fluid reservoir is a serious mistake and can have detrimental effects on your vehicle's braking system. Transmission fluid and brake fluid serve completely different purposes and have distinct properties. Transmission fluid is designed for lubricating and cooling the transmission components, while brake fluid is crucial for the proper functioning of the braking system. Brake fluid is a hydraulic fluid that transmits force within the brake system, and it has specific properties to withstand high temperatures. If transmission fluid is added to the brake fluid reservoir: Loss of Brake Functionality: Transmission fluid is not suitable for use in the brake system, and it lacks the necessary properties for hydraulic braking. Mixing the two can compromise the integrity of the brake fluid, leading to a loss of braking functionality. Damage to Brake Components: Brake seals, hoses, and other components are not designed to handle transmission fluid. The introduction of transmission fluid can lead to damage to these components, resulting in brake system failure. Reduced Braking Performance: Transmission fluid may cause the brake fluid to become less effective, leading to reduced braking performance. This compromises the safety of the vehicle and increases the risk of accidents. If such an error occurs, it is crucial to address it immediately: Do Not Drive: Refrain from driving the vehicle as compromised brake functionality poses a significant safety risk. Professional Inspection: Seek the assistance of a qualified mechanic to inspect and flush the entire brake system. Flushing involves removing the contaminated fluid and replacing it with the correct brake fluid. Component Replacement: Depending on the severity of the contamination, brake components may need to be replaced to ensure the safety and reliability of the braking system. In summary, mixing transmission fluid with brake fluid can lead to severe consequences, and it is essential to rectify the mistake promptly by seeking professional assistance to prevent safety hazards and potential damage to the vehicle.
Your brakes will start to shift and essentially turn into a second transmission effectively giving you double the gears. IE. Turning a 6 speed transmission into a beast of a 12 speed tranny. Vroom vroom. Nope. Better flush that system out immediately, darn good too. Don't go driving because brake fluid goes where brake fluid goes for a reason.
You have your car towed to a repair station where they will bleed the brake fluid and grease out of the brake system, and replace them with good, clean brake fluid.
drain all of it out. hopefully there will be no damage to the rubber components.
You are in for some expensive brake system repair work. I made this mistake once a long time ago and had to replace seals-gaskets.
Not in the transmission , but the hydraulic clutch on a Ford Ranger uses DOT 3 brake fluid
Transmissions are hydraulic just like your brake system or power steering system. Without transmission fluid you would have no hydraulic pressure for it to operate nor would you have lubrication. Trans fluid also has cleaners in it to clean your transmission as clutches, and gears wearaccumulate inside.
This question has appeared here before, and the answer is still no!Transmission fluid and brake fluid are two differentfluids. One of them (tranny fluid) works as a hydraulic agent like brake fluid, but also works as a coolant and lubricant, and it helps your transmission to grip the bands to transfer power. If it is low, the transmission will slip.Brake fluid is basically just a hydraulic fluid (though it does lubricate a bit), and it pushes caliper pistons which move brake pads against the brake rotor or brake bands which move against the inside of the brake drum. Brake fluid eats paint for breakfast, so you don't want that on the finish of your car. Keep reading 'cause there's more.Note: The real issue here is what the fluid does to the seals in the transmission or the brake system. These seals are specially formulated rubber, and the wrong fluid in them will work for a short while, but will permanently damage those seals. At that point, they will leak and all the seals in the system will have to be replaced and the system flushed and filled with the correct fluid. (If it's a transmission, you'll have to replace the bands and a few other parts as well as the seals. The bands are somewhat porous and absorb fluid.) It doesn't take a rocket scientist to see the issue here. Be smart. Consult a car expert or even a competent parts supplier for the correct fluid for your brake system or transmission.PS: M-EightTotally true my friend if put brake fluid in tranny simple way to say it is all seals will get eaten up by the toxics in brake fluid and tranny will leak like crazy, but he is asking about tranny fluid in brakes which will cause leaks like mad because of tranny fluid is alot thiner then brake fluid.Dont do it kids ! LOL
no, both trans fluid and brake fluid perform the same function, just have different properties and heat tolerances, make sure a professional flushes the brake system for you, this is the only way to flush it properly
go to a mechanic immediately