0
Add your answer:
Earn +20 pts
Why 1997 BMW 328i has growling sound when push gas pedal?
When you push the petal down to the floor and here a click, it undershifts a car, and results in a intense roar. When you push the petal down to the floor and hear a click, it undershifts a car, and results in a intense roar.
Your car rattles when you accerlerate on the gas petal?
not a rattle its called pinking, inferior fuel / timing to far advanced , try a new set of spark plugs first
What does it mean when you push the brake petal and the car revs up on a 1990 Crx?
The Brake booster needs replaced
What is the sentence for the word rattles?
The car rattles when I go fast in it.
When you push your break petal it goes to floor before it kicks in and it very weak What is wrong?
Master Cylinder is defective. Stop driving this car until you have this repaired.
What does a baby and an old car both have?
A rattle, or rattles.
Car rattles on the front right side?
check you ty rods and shocks.
The JL Audio Stealthboxes are designed to minimize rattles in your car. I would suggest installing it then addressing any rattles then. We sell Hushmatt that has a higher heat adhesion factor than Dyn?
The JL Audio Stealthboxes are designed to minimize rattles in your car. I would suggest installing it then addressing any rattles then. We sell Hushmatt that has a higher heat adhesion factor than Dynamat. Here is a link to the products. http://creativecaraudio.net/c/car-audio_accessories_sound-proofing-material
Why wont your car start and when it start why does it rattles?
Maybe Its The Muffler or the pistons hitting the engine
Why is there a grinding noise and brake petal vibration while braking your 2000 after that happens the abs lights turn on?
Your brand pads are worn out. Stop driving this car until you can have the pads replaced.
Why is there a grinding noise and brake petal vibration while braking your 2000 Avalon after that happens the abs lights turn on?
Your brand pads are worn out. Stop driving this car until you can have the pads replaced.
How do you bleed the clutch in a 2005 gto?
Make sure the master cylinder is kept full of fluid at all times and put your helper inside with foot on clutch petal, with the car jacked up and stands in place locate slave cylinder on drivers side and place a 11mm wrench on the bleed valve,. have the cockpit man push on the petal and hold it down, then open valve and let air and fluid escape being careful not to get fluid in eyes, tighten valve and tell helper to let petal return. its petal down-loosen-tighten-petal up. Repeat this process several times to remove air.
