0
Add your answer:
Earn +20 pts
Why would a brake pedal held to the floor suddenly lose tightness and brakes not working?
Have your brake system checked immediately! (by a proffesional)
What to do if your foot brake suddenly loses power?
Rapidly pump the brake pedal.
What happens when the master cylinder goes out in a Buick Skylark?
When you press and hold the brake pedal it will slowly move to the floor. It can also have a catastrophic failure and go straight to the floor with no stopping ability at all. If you hold the brake pedal down and it slowly moves to the floor any at all, replace the master cylinder.
What are the symptoms of a defective master cylinder?
usually they will leak out the back by the booster, your brake pedal will slowly go to the floor at stops or the brake pedal will go right to the floor when pushed.
What causes brake pedal to go half way to the floor on a 1999 ford explorer?
Something is impairing the brake pedal to go to the floor. Only a mechanic can tell you what is happening.
Can worn brake pads make your brake pedal to go to the floor?
no you have a brake fluid leak somewere
1997f-350 brake pedal goes to floor?
ouch,are brakes adjusted correctly/ sit in vehical and pump pedal to get a full pedal,then hold pedal to see if it bleeds off and goes to floor,if it stays, replace shoes and pads if it goes to floor, there is a fluid leak somewhere is there brake fluid in the resevoir/ are there any brake fluid leaks ,check backside of wheels there is a brake fluid pump, on the chassis rail about level with the front of the front door on the left side.if this pump is bad your pedal will go to the floor
What happens when you run out of brake fluid?
The brake pedal will go to the floor but will have absolutely no effect on stopping the vehicle. When you push on the brake pedal it moves the fluid through metal tubes (called brake lines) to force the brake pads against the rotor which slows and stops the car. No fluid means nothing is in there to make the brake pads engage the rotors.
Why does the parking brake pedal go to the floor on a 97 suburban?
probably have broken parking brake cable.
What happens when the brake pedal is released?
Pressure is released from the hydraulic system and brake pistons relax.
Can the brake booster cause your brake pedal to go to the floor?
No, a busted brake booster will not cause the brake pedal to go to the floor. It will however cause the brake pedal to be extremely hard to push. A defective master cylinder will cause what you describe. Replace the master cylinder and bleed the brakes. It can because it happened to me. The booster lost vaccum and the pedal went to the floor. Sorry, you are wrong. The only reason the pedal went to the floor was because the master cylinder failed. The brake booster only boosts the pressure on the master cylinder and allows you to not have to push so hard on the brake pedal. Cars of yesteryear did not even have a brake booster and they stopped just fine albeit you had to push the pedal allot harder than with power brakes. A failing brake booster will not cause your pedal to go to the floor although it might cause it to go lower than normal before the brakes apply. As long as the master cylinder is good you will still have brakes, but you will have to really push hard and might even have to pump them up in order for them to stop the car.
Why do the brake lights on a 1992 Mustang only come on when the brake pedal is pushed all the way to the floor?
The brake light switch is out of alligment. Check on the brake pedal arm and readjust the switch.
