there will be to much pressure and your engie will brake down you have to drain some of the oil
If the level of oil reaches the rotating crankshaft it will foam the oil, making the oil lose its ability to lubricate properly.
It depends on what you SHOULD have put in and what you DID put in and the age of the engine. Most of the time it won't make much difference.
the oil will aerate causing insufficient lubrication drain some out recheck and top off good luck
The oil will make contact with the crankshaft. This will create a froth of oil mixed with air. This is a poor lubricant and will cause severe engine wear.
It depends on how much you put in ,it will probley smoke some from the tail pipe if you get to much it may foul the spark plugs,and cause it to run poorly,did you put some in by mistake? how much? artie
Too much oil can be just as bad as too little. The excess oil can make contact with the crankshaft and cause cavitation. This will mix air with the oil. This mix creates a froth that is a poor lubricant. Drain out any excess oil.
Bad very very bad.... engine will get too much oil and overheat and go boom... lots of smoke...
it will pollute the water
hw much gearbox oil do you put in your ktm 525
it will seize up
It becomes soap.
Too much oil is just as bad as too little oil if you overfill it enough to allow the crankshaft to make contact with the oil. This will create a froth of oil mixed with air. Air is an extremely poor lubricaant and this air mixed with the oil will cause severe engine wear.
they look and feel good