0
What else can I help you with?
Why wont your 94 Chevy lumina stay running in idle try to give it gas and it stalls it runs for a few then dies Ive replaced the fule filter but it still sputters and dies like a sensor is bad?
You have to change the mass flow sensor
How to check the solution to an integer equation?
insert the answer in the equation, replacing the variable, and see if it still makes sense.
Is my 1985 iroc fuel pump bad or is the filter clogged its whirring car is starving for fuel and stalls?
Could be either. Start with replacing the filter then if it still has trouble do a fuel pump pressure and leak down test.
You changed the alt now the car still stalls when it run for a while it shut downs?
While replacing the alternator a vacuum line might have been disconnected or something like that... inspect for something loose close to the alternator dave
I changed the fuel filter for my mustang 1997 but it still stalls a little.?
Check the screws and rubber gasket on your fuel pump.It is often caused by air penetration on your fuel line.
What should the technician do if a lawn mower engine sputters?
Check the condittion of the spark plug first if ok then check the air fillter and blow out. If it's still doing it check the jet in the carb and blow out the holes making sure it is clear. If this doesn't work then you are into timing problems or valve settings but I don't think it is as serrious as that.
Why after replacing the water pump hoses and the thermostat on a Honda 2000 CRV it is still running hot?
Check the radiator fan operation.
Why would check engine light still be on after replacing 02 sensor on 2000 grand prix gtp?
There is another cause for the code.
Replacing a Neutral Safety switch on a 95 S10 still will not start?
If ignition problems still persist after replacing the neutral safety switch on a 1995 Chevy S10 check the starter. A broken starter will result in a car which will not be able to turn over the engine.
Why is my fire alarm still beeping after replacing the battery?
If your fire alarm is still beeping after replacing the battery, it could be due to a few reasons such as a faulty battery, improper installation, or a malfunction in the alarm itself. It's important to check the battery connection, ensure it is the correct type of battery, and if the issue persists, consider replacing the alarm unit.
After a tune-up on your 1989 Dodge Ramcharger it still miss-fires and stalls at red lites Any ideas?
Check the air cleaner element, and replace if dirty. Replace the fuel filter.
After replacing the ac compressor on a 2000 Chevy Malibu and adding refrigerant the compressor still will not turn on?
check fuse or relay in underhood fuse box,
