The parking brake wire is located under the center console. Around the parking brake there is a wire that routes to handbreak, it is normally green.
just ground the parking brake wire
what color is the negative parking wire and where is located
in some cars the parking brake has a different brake bad than the one that you use to brake your car you might need to cvhange the brake bad for the parking brake the parking brakes works through a wire if the wire looses up it will will not work probably you might need to tighted this wire or maybe the wire is cut completelly
The wire should rest at 12V+ or zero but when the parking brake is on the wire goes 12V- .
Kenwoods are very simple to bypass for the parking brake. Just take the parking brake wire which is usually green and ground it. That's it!
Underneath.
Its very simple to bypass the parking brake on Kenwoods. All the parking brake wire is is a ground wire. So, all you need to do is take the parking brake wire and either ground it or join it to the ground wire on the harness by soldering or whatever you wanna do.
Hello. Bypassing a parking brake on a Pioneer radio requires an interface. You can not just ground the parking brake wire. You can buy them on Ebay or Amazon.
Most cars have drum brakes in rear which the parking brake manipulates. Take off both rear wheels and brake drums. You should see a wire system inside that continues out the rear of the brake housing. This is the parking brake wire. Spray it with WD-40 or an equivilant rust penetrating oil. If this does not work, disconnect the wire from the brake mechanism and the brakes should release.
gound it put the wire in the ground of the car sterio
Connect green wire ( handbrake ) to Ground (earth)