answersLogoWhite

0

For a 2000 Jeep Grand Cherokee 4.7L Limited, the torque settings vary depending on the specific component being worked on. For example, the cylinder head bolts should be torqued to about 75 ft-lbs in a specific sequence, while the intake manifold bolts typically require around 20 ft-lbs. It's essential to consult the vehicle's service manual for precise torque specifications for each component to ensure proper assembly and function.

User Avatar

AnswerBot

1d ago

What else can I help you with?

Related Questions

What are the tie rod ends torque bolt settings on a 2000 Jeep Grand Cherokee Laredo FWD?

The tie rod torque bolt settings, on your 2000 Jeep grand Cherokee, is 70 pounds per square inch. The bolts should be torqued in 35 pound intervals.


Why does your 1997 jeep grand cherokee limited shift to first and second and not overdrive?

Check for a blown TCC (Torque Converter Control) fuse.


Will a 97' Grand Cherokee torque converter fit a 93?

No.


Where is the torque Converter clutch on 97 jeep Grand Cherokee Laredo?

It is inside the torque converter.


What are flywheel bolt torque settings on a 2000 3.1 TD grand Cherokee?

For a 2000 Jeep Grand Cherokee with a 3.1L TD engine, the flywheel bolt torque settings are typically around 70-80 ft-lbs. It's important to follow the manufacturer's specifications and use a calibrated torque wrench for accuracy. Additionally, always ensure that the bolts are properly lubricated if specified in the service manual. Consulting the vehicle's service manual is recommended for the most accurate specifications.


What is the front wheel bearing torque spec for 1996 grand Cherokee?

It is 175 ft lbs for the front wheel bearing of a grand cherokee


Where is the 1999 jeep grand Cherokee ac drain?

where is the ac drain on 1999 jeep grand cherokee limited


Is there a drain plug on a torque converter for a 95 jeep grand Cherokee Laredo?

No. The torque converter does not have a drain.


When replacing the valve cover gasket on a 2004 jeep grand Cherokee limited- 6-cylinder 4.0L what is the correct torque or sequence for tightening the screws on the valve cover?

The correct torque spec is 85 INCH lbs.


Will the door off a 94 Jeep Grand Cherokee Laredo fit on a 93 Jeep Grand Cherokee limited?

Yes


What are the cylinder head bolt torque settings on a 1998 jeep grand Cherokee 5 point 2 L V8 engine?

85 ft/lbs


What is the torque settings for valve cover screws on a 2000 Jeep Grand Cherokee with a 4.0 engine?

Should be 10 in.lbs. I believe this would be 10 ft lb not inch lb