answersLogoWhite

0


Best Answer

this problem could be your mass air sensor, or the problem i had when this happened to me was the catalytic converter is breaking apart on the insid clogging your exhaust.

User Avatar

Wiki User

14y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Rough idle after braking but not in park or neutral?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

What is the RPM at idle for 86 cutlass supreme?

the idle should be about 900 RPM in park or neutral.


When does the engine have noise idle rough?

when stopped at red light or when in park


What P R N D S B?

Park Reverse Neutral Drive Super Braking


Why does your 1987 Grand Wagoneer idle poorly in drive In park and neutral it idles great?

check your timing & up your idle a little


What causes a Park Avenue to run rough or misfire and stall at redlights?

Check the Park Avenue EGR valve for a clog. A clogged valve can cause a rough idle and stall at a light.


What causes a car to not idle in gear but not while in park or neutral?

A vacuum leak (Brake booster).


Mi Mazda milenia 98 has high idle spped when its in neutral and in park what is it?

Normally when you park it isn't moving therefore 0


What is the transmission park?

Park on a transmission is a gear that allows the transmission to idle as if its in neutral while locking the drive train to prevent the vehicle from rolling.


Rpm increases when car is in park?

It is normal for the RPM to increase a little when put in park or neutral. If the RPM increases by a lot, then you need to adjust your idle speed.


What is the idle for 2003 Nissan Altima?

No load in park or neutral 700 give or take 50rpm With A/C around 800rpm


Why does a 1992 k1500 idle and take gas in park or neutral but wont take gas in gear?

Could be a very dirty fuel filter.


Why would your 38L idle at 5000 RPM when in park or neutral?

It shouldn't idle that high the factory idle setting is around 900 RPM's check to make sure nothing is sticking and check vacuum lines. Good luck fixing your problem.