No it isn't the vehicle will not run with out it. Unless it has been bypassed somehow. (EFI) stands for electronic fuel injection the vehicle will not get gas without it.
The EFI fuse is in the underhood fusebox on your Tacoma, it's labelled EFI, so identifying it is easy. Pull firmly.
The EFI fuse for a 2001 SLK 230 is located in the fuse box, which can be found under the dashboard on the driver's side. You may need to remove a cover to access it. The specific fuse for the EFI system is typically labeled in the fuse box diagram, so refer to that for the correct fuse number. If you're unsure, consulting the owner's manual can provide further guidance.
open fuse box remove efi [fuel injector fuse for about10 seconds
The EFI fuse on a 2005 Lexus ES330 is located in the engine compartment fuse box. To access it, open the hood and find the fuse box, which is typically near the battery. The EFI fuse is usually labeled, so you can identify it by checking the diagram on the lid of the fuse box. Make sure to replace it with a fuse of the same amperage if needed.
not sure what you are asking exactly. If you are asking how to reset your ECU, simply remove your battery cables for 2-5 minutes and that should do it. Or. Remove the battery cables and the following fuses/relays. Efi Fuse Efi Main Relay Haz/Horn fuse and wait 5-10 minutes.
remove the efi fuse for 1 minute if the light comes back on you have a problem
The EFI (Electronic Fuel Injection) fuse on a 1999 Lexus GS300 is located in the engine compartment fuse box. To find it, open the hood and look for the fuse box near the battery. The specific EFI fuse is typically labeled in the diagram on the cover of the fuse box. If you need to replace it, ensure the ignition is turned off before removing or inspecting the fuse.
Remove the negative battery cable for 30 seconds. Or you can remove the fuse in the under-the-hood fuse panel marked "EFI" for 10 seconds. This works on most all Lexus models from 90-95.
As you face the front of the 4Runner, you will see the battery at the front right. The FUSE BOX is just beyond the battery. The top of the fuse box has a panel which identifies each fuse. The EFI fuse is the MIDDLE FUSE, closet to the right fender.
First of all this is like going back in time. The conversion will depend on they type of EFI you have. If you have a multiport EFI system then you will need to remove the intake manifold and get a carb intake manifold, remove all of the extra sensors, remove the computer, remove the wiring harness. Then you have to purchase a wiring system for your application, purchase and jet a carb and bring your car to a good tuner to tune the vehicle.
On a 2001 Toyota Sequoia, the fuel pump is located on top of the fuel tank. The fuel pump is powered by the EFI fuse and EFI relay.
In the engine bay , on the right side there is a fuse box , take the cover off , and turn cover upside down to see which on is the EFI fuse , if im not mistaken its the second to last , a green 30