Definitely not excessive. Excessive becomes in high RPM range (6000+) and ONLY if the engine components are not designed to withstand RPMs that high, or if one or more components are faulty so the higher you rev, the more chance it has to break down completely.
Cylinder miss.
idles at 3000 will not go down 1993 grand prix gtp
3000
It is: 3000 because 457 is less than 500 so you round down instead of up
No, PSP 3000's cannot be downgraded.
Less. If the pedal is going down, it is the master cylinder or one of the wheel cylinders leaking.
Sounds like u need a new master cylinder, dont mess around with breaks, its better to be safe then sorry. When a master cylinder wears out it no longer holds the pressure and will cause the pedal to go to the floor. Also check your brake fluid level, if it is going down u may have a leak. Have your breaks looked at asap.
you down load the program chikhen
The "cylinder jug" is the cylinder. This is the area that the piston and piston rings moves up and down in when the engine is turning.
By bringing down 3000 watts of light.
clamp the line to the slave cylinder and mash the clutch pedal. if the pedal gets hard to push,the slave is bad. if the clutch pedal goes down slowly with moderate pressure,the master cyl is bad clamp the line going to the slave cylinder. meant to say that in the previous answer
Master cylinder reservoir is located on the bulkhead. If you mean where is it going. as the front brake pads wear down the master cylinder level drops slightly. A sudden drop in level indicates a leak somewhere in the system.