I dont understand, is your car overheating or do you think your switch is overheating?
Switches do not overheat, if they become hot to the touch there is a grounding problem which would have most likely blown a fuse at some point.
did you have your ignition coil replaced? the signs are that the ignition coil is overheating thus you are able to restart after an hour, when the coil cools. also check if your ignition coil has a resistor. if it has, have it checked for continuity. did you have your ignition coil replaced? the signs are that the ignition coil is overheating thus you are able to restart after an hour, when the coil cools. also check if your ignition coil has a resistor. if it has, have it checked for continuity.
Probably ignition switch. Have it checked out.
It is important to know the symptoms of a part going bad. The signs of an ignition switch going bad is it overheating, no clicking when trying to start, the car has issues starting and running.
The ignition switch could be bad if a Hyundai Elantra has no crank and then starts. The fuses which are tied to the ignition should also be checked.
Have you checked the ignition switch on the column . I had to replace the one in my 1977 Trans Am.
You mean, I think, ignition switch module, which is the location of the ignition switch.
CHECK THE IGNITION SWITCH,,, THEY HAVE A HABIT OF GOING BAD
Remove the ignition switch retaining ring. Pull the ignition switch out. Remove the wiring harness from the back of the ignition switch. Reverse the process to install the new ignition switch.
Begin by removing the retaining ring at the top of your ignition switch. The ignition switch will slide out and you can remove the wiring harness from the end of the ignition switch. Reverse the process to install your new ignition switch.
Probably the ignition switch. HavE IT CHECKED OUT> neutral safety switch......located under the shifter panel
Attach the wiring harness to the and of your 1986 Chevrolet Caprice ignition switch. Slide the ignition switch into the ignition slot. Tighten the ignition switch with the retaining ring.
The 1992 Plymouth Cold ignition switch is held in place by a retaining ring. Remove the retaining ring at the top of the ignition switch. Pull the ignition switch out. Remove the wiring harness from the ignition switch. Reverse the process to install the new ignition switch.