0
Add your answer:
Earn +20 pts
2 If your brakes fail one of the first things to do is .?
pull over to the right side, down shift and look for the safest escape route.
If your brakes fail one of the first things to do?
Downshift, apply e-brake and look for the safest path to avoid injury. Most parking brakes these days are just that, "parking brake" so don't expect much when you apply them.
True or false if the service breaks fail apply the parking break in one motion?
It if false that is the service brakes fail to apply the parking brake in one motion. It should pumped.
If the brakes fail on your vehicle the parking breaks may be used to help stop the vehicle as well?
Yes, the parking brakes can be used to stop the vehicle in emergency. But remember that, in most of the vehicles parking brakes apply only to one pair of wheels, so if the vehicle is in high speed, one has to apply them carefully and save the vehicle from skidding.
Why is your abs light on trail blazer?
It is one because there is a problem with the ABS (automatic braking system). You need to have it checked. The brakes could possibly fail without warning.
Why would someone need to use a barricade?
You may use one fore home securrity. There are also types of baracades to keep your car from moving if the brakes fail.
How can you take a drug test and fail one day pass the next and fail the next and pass the next?
Yes, if you get high after the first test!
Are there special tools needed to replace the rear rotor and pads on a 1997 Legacy GT?
first off are they disk brakes, (like the front one)? or drum brakes?
How does one change one's own drum brakes?
First you must lift the car using a jack or lift. Then remove the wheel. The brakes is behind it and is held on with nuts and bolts. Remove these and simply put a new brake one.
I think visiting this one is wasting of time What is the use of this website?
to educate others about things that other websites fail to answer
How can I adjust bike brakes if they are rubbing on one side?
To adjust bike brakes if they are rubbing on one side, first check if the wheel is properly centered. If it is, adjust the brake caliper by loosening the mounting bolt, centering the brake pads, and tightening the bolt. Test the brakes to ensure they are aligned and not rubbing.
How do you reset the anti-lock light on your 2000 intrigue?
go to a mechanic with the antilock break computer. but you will find they want to replace the ABS computer then they will find the actual problem that plagues all intergue's the screw jacks on the actuator motors fail. some have actuall caused the back brakes to stop functioning. replace the actuator first, used or new. just make sure the used one did not come from a car hit in the front(bad brakes!) then bleed the master cylinder and brakes. be careful this could result in brake failure.
