0
I just had my upper intake replaced and now my car makes a noise when I go from Park to Drive. The Mechanic said it was loose engine mounts. Did they cause this when they repaired the upper intake?
Wiki User
∙ 12y ago
they shouldn't have touched them replacing an intake. this sometimes happens over time and also sometimes they break. if they are loose, all it takes is 5 minute to tighten them back down. easy fix.
Wiki User
∙ 12y ago
Add your answer:
Earn +20 pts
In Jan. of 2009 you had the intake gasket replaced on your 1997 Chevy Malibu it is the end of march 2009 and your engine blew in the same vehicle without warning could your mechanic have forseen this?
no,unless he did something wrong!
How much does it cost to have a Mazda MVP air intake gasket repaired?
I had the upper intake gaskets replaced at a cost of $181.00 but this also included new spark plugs. Two intake gaskets $18.50
Where is the intake gasket located on a 2002 Chevy Malibu?
It is inside the engine between the intake manifold and engine block. Replacing it takes about ten hours for an experienced mechanic. An inexperienced mechanic like you would probably spend twenty hours before giving up and taking it to a pro. To help the pro reassemble your engine, at least write down the distributor position and label the pushrods.
When I replaced the intake manifold on my Lincoln townacar the engine knocks real load any ideas what this could be?
I replaced a 1995 town car intake it also knocks now. Not sure. I'll post later when I find out why.
How to replace Nox sensor on 2003 Chevrolet 5.3 engine?
There are 2 knock sensor on the 5.3L engine. And they are under the intake manifold. To get to them you will have to remove the whole top of the engine- INTAKE MANIFOLD. Why do you think they need replaced???? check engine light came on for 2 sensor
2005 gmc 6.0 knock sensor location and how do I replace it?
There is 2 on the 6.0L and both of them are underneith the intake manifold. You MUST remove the intake/ TOP OF ENGINE. To change them. IF YOU ARE NOT A MECHANIC, then you need not do it yourself.
1997 silverado vortex 350 engine intake manifold gasket blew water and oil mix ended up being sucked into intake replaced oil plugs oxygen sensors but engine missing at most speeds ran perfect before?
replace intake manifold gaskets, if gaskets have been replaced and intake has been clean oil and plugs have been changed then your problem most likely would be the timing.timing the distibutor on a vortex engine sometimes can be tricky.
Can a Dodge Neon 1998 SOHC 20 engine be replaced with a 2000 engine?
Yes it can. The engine is exactly the same except for the throttle body an intake. Just use the ones on the old engine.
Where is the intake air temperature sensor on a 1995 Ford F250 with a 7.5 liter engine?
I'm not a mechanic / technician but I believe that is installed in the upper section of the engine air filter box
Intake manifold leak in 2000 Monte Carlo?
If it's the 3.1 or the 3.4 that's typical for that engine, you will have to get it fixed immediately or risk hydro locking the engine and then you will be buying a new engine, figure between $550 to $650 to have it repaired.
Why would our intake manifold crack on our 2002 Saturn?
This is a common problem for all Saturn S-Series 2000-2002. The plastic intake manifold cracks at the coolant stems, even if the engine does not overheat. This is especially true in the southern half of the US (hotter climate). The intake manifold would need to be replaced, or repaired so no further damage will occur like overheating the engine. CarSaturn of Conyers, GA sells a repair kit to fix this problem- Worked for me. Link is below www.carsaturn.com Good Luck!
Repair the Intake System?
form_title=Repair the Intake System form_header=The intake system helps keep the engine running at top performance. Has your car intake system every been repaired before?= () Yes () No Do you want us to check out the complete car intake system when we do repairs?= () Yes () No Will you be using insurance to pay for these repairs?= () Yes () No
