The owners manual states 1.7l (1.8 quarts). I just did the 8 hour oil change and it took 1.8l to register as full. This amounts to almost 2 bottles (.95 liters in each bottle).
It's a lawn tractor.
It's on the frame but it's also on a sticker under the seat.
1.8 qts
To replace the solenoid switch on a John Deere X300 tractor, first disconnect the battery to ensure safety. Remove the old solenoid by disconnecting the wiring and unscrewing it from its mounting location. Install the new solenoid by securing it in place and reconnecting the wiring according to the original configuration. Finally, reconnect the battery and test the operation of the starter.
Put it on
It helps to have a schematic in changing the traction drive belt on a x300 John Deere. Making the area accessible can be tricky. Once it has been revealed, it can be accomplished simply.
with a pair of channel locks or a pipe wrench
Front and Rear tires - 10 to 14 pounds for the soft tread turf tires.
To adjust the throttle on a John Deere X300, locate the throttle lever, typically found on the right side of the operator's seat. To increase the engine speed, push the throttle lever forward; to decrease it, pull it back. Make sure the engine is running while you make adjustments, and always follow the manufacturer's guidelines in the operator's manual for specific instructions.
It would seem a fair price, but you should first look around for comparable models for sale. I'm looking online, and there's a 2006 model with 546 hours, 17 horsepower, and a 42 inch deck going for $1500, for example.
According to my manual the x300 is a closed and sealed transmission unit. No adding hydraulic fluid for the do-it-youself mechanics. Suppose there is a way but I believe that the dealership has to do that work if it's needed.
7,987 JD 4000 tractors were built