The Sentry Safe that I have is .41 cubic feet. It is black with a gray keypad. I looked around the internet for the answer to this question myself. It seems that there are some Sentry Safes that allow you to disable the keypad beeps through a series of keypad presses. It appears that the safes that do have this option have directions for such in the user manual. Mine does not apparently have this option. So to disable the beeps I did the following:
1. opened the safe
2. took out the three screws holding the box on the inside of the door
3. took a pair of pliers and removed the black, round plastic component which happened to be labeled "speaker"
4. reassembled
And there you have it. No beeps when the keys are pressed.
WARNING: This method permanently disables the speaker. So if there is some kind of low battery warning that might sound or something like that ... you obviously wont hear it. So make sure your override key is somewhere safe and handy in case you need it (NOT IN THE SAFE).
The better thing to do is press 0 then prog enter, this puts the safe in stealth mode no beeping when you press keys, but still beeps if you have a low battery.
Clicking on your seatbelt will turn off the seat belt reminder beep.
Clicking on your seatbelt will turn off the seat belt reminder beep.
Hold the wave#/reset button till it beep
it is virtualy imposible
The beeping is just telling you that the machine is turning off.
Firstly, turn the ignition on but don't start the engine, then turn the headlights on, then off, then turn them back on, then off again. (so twice on, twice off) the car should beep at you twice indicating this function has been switched on. To switch off, repeat the same steps above and the car will only beep once.
My '96 Mercedes C220 has a constant beep in the dashboard and there is no lights that indicate a problem Anyone got an answer for this???
Unplug the small speaker located in the front of the inside of the PC
To reset a PS3, turn it off, then turn it back on again. or if you want to reset the whole system just turn it off and hold it till you here 2 beeps then a double beep.
All you have to do is buckle it for a couple of minutes. Then take it off NO BEEP until you restart your truck.
if should do. but if you are turning it on by the controller it wont beep
It will sound an alarm through the receiver that goes beep beep beep.