Fill it with gas, pump the throttle 3-4 times, then start normally.
You say it runs when gas is poured in the engine but not with the key start. Two questions: (1) where in the engine are you pouring gas, and (2) how are you starting the engine if not with the key? If you mean you are pouring gas in the carburetor or in the spark plug hole and it starts with the key, but doesn't start if you don't pour gas in, the needle valve on the carburetor may be closed or the float may be stuck in the closed positiotion. You might also want to check the throttle linkage.
Gas
# Put gas into the gas tank # Turn the ignition key to "on", but not start and wait until the fuel pump stops. # Do #2 several times # Attempt to start engine normally. # Refill gas tank at ¼ tank next time.
Refuel the vehicle using jerry cans and restart the engine. It will likely take more than one, depending on the size of the vehicle and how far the nearest gas station is.
what if he gas is going to the engine but the car want start?
do you have to do something else besides putting gas in it to start a daewoo lanos when it runs out of gas
Yes, you should prime the engine after your snowblower runs out of gas, especially if it has a primer bulb. Priming helps to draw fuel into the carburetor, making it easier to start the engine again. After running out of gas, it’s important to refill the tank with fresh fuel and allow the primer bulb to fill the carburetor before attempting to start the snowblower. This ensures proper fuel flow and smooth operation.
Put more gas in it silly
gas
put a little bit on gas in the carb and start it up
Not unless it is a carburated engine.
YES!