answersLogoWhite

0

first your two roll in their compartment,run under the little plate before exiting and then going thru the two tension aid springs and then both thru the 1st porcelain,then divide for each porcelain on needle and go tie at base of needle and then engage manually for tiyng knot and then rotate whole system by hand by turning the flywheel.

Gidday, I am self-taught on the 503, but after threading the needle, I pass the twine straight up through the gap in the knotting mechanism, against the thingy with the multiple serrated discs, then tie it back to the bale density adjuster at the back. After the first bale it will cut the twine then you can remove the remaining bit of twine with the knot you tied.

User Avatar

Wiki User

13y ago

What else can I help you with?

Related Questions

How do you time Massey Ferguson Model 12 hay baler knotters?

How do adjust the knotters on #12 Massey Fergurson hay baler


Massey ferguson's 12 hay baler timing?

To set the timing on a Massey Ferguson 12 hay baler, you'll need to ensure that the plunger and the knotters are synchronized properly. Generally, this involves adjusting the timing gears so that the knotters engage at the correct moment as the plunger reaches the end of its stroke. It's crucial to follow the manufacturer's specifications in the operator's manual for precise adjustments. Regular maintenance and inspection of the timing mechanism can help ensure optimal performance.


What length are the leading 3 fingers on a Massey Ferguson 503 hay baler?

The leading three fingers on a Massey Ferguson 503 hay baler typically measure around 20 inches in length. These fingers are designed to effectively gather and feed hay into the baler for optimal baling performance. It's important to consult the specific operator's manual for exact specifications, as measurements can vary slightly based on the model and year.


What would cause a plunger on a Massey Ferguson model 3 hay baler to stick?

A plunger on a Massey Ferguson model 3 hay baler may stick due to several factors, including a lack of lubrication, debris or hay buildup in the mechanism, or wear and tear on components like the plunger bearings. Corrosion or rust can also impede movement, especially if the baler has been stored improperly. Regular maintenance, including cleaning and lubrication, is essential to prevent these issues and ensure smooth operation.


What is a hay baler tucker finger?

A hay baler tucker finger is a component of a hay baler that helps to guide and position the hay as it is fed into the baler. It works by "tucking" the hay into the pickup mechanism, ensuring an even and consistent flow of material into the baling chamber. This aids in the efficient formation of bales and helps prevent clogs. Tucker fingers are crucial for maintaining the overall performance and productivity of the baling process.


Does anyone make an ATV hay baler?

No.


When was the hay baler invented?

The inventor of the hay bailer was a man named Innes. It was invented in 1936. the hay bailer was not the large round bailer but the small square bailer


Is a round baler or a square baler more expesive for the same amount of hay?

A round bail of hay is cheaper. The cost of a single bail of hay times the amount in a regular round bail is alot more in price. A round baler is more expensive.


Where can one purchase a hay baler?

One can purchase a hay baler from a store which offers farming equipment such as hay balers. They can also be purchased online from general retailers such as eBay, which will usually be second hand.


Who invented the round hay baler?

New Holland


Where was the hay baler invented?

have no clue but Ed Nolt invented it


How does a hay baler work?

hay is picked up by a the pickup tines, then pushed perpendicularly by a "fork". it is then compacted into slabs by the plunger and tied with twine by the knotters. the bale then comes out the back of the baler.