As I recall, it was a matter of turning off the radio, pressing SET, and then holding SEEK or SCAN to set the hours or minutes. When finished, press SET again.
Turn on the power knob for the radio/clock. Wait until the clock display shows up. Press "set", and use the "scan" and "seek" buttons to set the time. Hope this helps!
hold in the minutes or hours button 30 seconds then sset then release to lock in the time
Turn off the radio press set adjust hour with scan button adjust minute with search button
Press the set button then within 10 seconds press the seek and scan buttons to change time.
So, what's the answer to my question? How do I set the dashboard clock on my 1983 Buick Riviera?
If I remember correctly, you have to pull out the radio buttons that don't correspond to #1 through 6. Hold it out for a while and it will begin to change the hour or the minute.
The spark plug gap for a 2003 Buick LeSabre should be set at .060 inches. The best spark plug for this vehicle would be an Iridium plug.
To set the clock on a 1989 Corvette the radio must be turned off. After turning the radio off hit the set button and then hit scan. The time can be set using the arrow buttons.
You could try learning celsius like the rest of the world. ;-)
i have 2004 lesabre. you look in your owners manual for sure turn engine off turn on enine, but do not start press and hold the HR button, small button on right of radio then press and hold other button for minutes until right minute there is a button for AM PM too or you may have to use one of the other
Press "SET" and then use the keys on the bottom right of the radio.
with the radio off use the seek buton to set the time