The procedure can be found in the drivers manual.
How do you reset 2008 honda element service light?
You can't reset that light...there is no such thing as a 2002 Honda Element...they didn't come out until 2003.
To reset the wrench light on a Honda Odyssey after an oil change, turn on the ignition without starting the engine. Press the gas pedal three times within 10 seconds. Then, turn off the ignition. When you start the vehicle again, the wrench light should be reset.
One way to reset a 2005 Honda Element check engine light is to disconnect the battery. The battery will need to be disconnected for about 5 minutes for the light to reset.
You take out the battery and reinsert it.
This is how it is done on a Honda Accord and your Element should be the same. Push and hold the odometer reset button in while at the same time turning the ignition switch to the on position without starting the engine. After 5 seconds the light will reset.
It must be reset by a Honda Dealer. The light is on because there is a problem with the system. I am sure you do not want the airbag to not function as it should or prematurely deploy.
Means the oil change reminder needs to be reset.
The wrench symbol on a 2012 Honda CR-V indicates that the vehicle is due for scheduled maintenance. This warning light typically appears after a certain number of miles or time since the last service. It serves as a reminder to check and perform necessary maintenance tasks, such as oil changes or inspections, to ensure the vehicle runs smoothly. If the light remains on after servicing, it may need to be reset.
Here is how you reset it on an Accord so I would think it would be the same on an Element. Push and hold the odometer reset button while at the same time turning the ignition on without starting the engine. After 5 seconds the light will reset.
how do you reset the clock on a 2005 Honda accord how do you reset the clock on a 2005 Honda accord
To reset the maintenance light in a 2005 Honda Element, start by turning the ignition to the "ON" position without starting the engine. Press the gas pedal three times within five seconds. After doing this, the maintenance light should turn off. Finally, turn the ignition off and then start the engine to ensure the light has been reset.