answersLogoWhite

0

buy the indicator, yes u need a new indicator should be about $35 bucks per side

part number MC886395. Once the brakes go past a certain point it burns the indicator out and you will need to replace that and the brake pads and or rotors so dont let the brakes get that bad if you dont wanna replace this part too.

User Avatar

Wiki User

13y ago

What else can I help you with?

Related Questions

How do you reset disc brake warning light on 2004 325i?

To reset the disc brake warning light on a 2004 BMW 325i, you typically need to use a diagnostic tool or follow a manual reset procedure. If you have a diagnostic scanner, connect it to the OBD-II port and clear the fault codes. Alternatively, you can turn the ignition to the "on" position without starting the engine, then press the brake pedal three times. If the light persists, ensure that the brake pads are properly installed and that the brake fluid level is adequate.


How do you reset the disc brake light on A Mitsubishi fe180?

To reset the disc brake light on a Mitsubishi FE180, first ensure that the brake system is functioning correctly by checking the brake fluid level and inspecting the brakes. If everything is in order, turn the ignition key to the "ON" position without starting the engine. Press the brake pedal three times within five seconds; this should reset the brake warning light. If the light remains on, consult the vehicle's manual for specific procedures or seek professional assistance.


How do you turn brake pad warning light on vw golf 2007 gt tdi?

the only way you change brake pad or disc


How do you turn off brake pad warning light on a vectra?

reconnect the sensor at the back of the disc caliper.One of them has come off-just press back on


How do you reset light after disc pad change on mini 2007?

To reset the brake light on a 2007 Mini after changing the brake pads, turn the ignition key to the "on" position without starting the engine. Press the accelerator pedal three times within 10 seconds. This should reset the brake light indicator. If it doesn't turn off, you may need to use a diagnostic tool to clear any remaining codes.


What width is to narrow for a worn brake pad?

Do not let them get down to the rivets. On disc brakes they have a warning tab installed.


What are disc brake components?

disc brake components


Is a disc brake the same as a rotor?

The rotor is the disc in the disc brake system.


Peugeot 106 dashboard light its yellow with a black circle in it and comes on when i press the break?

just you brake pad warning light.. need new front pads, possibly disc get check the pad thickness ASAP! (inside pads are always thinner)


How do you turn off the ESP warning light on a Renault Laguna?

You probably need new rear disc bearings. Once you install the new bearings, the warning light should turn off.


Excessive brake disc 'run out' indicates that a brake disc is?

worn thin


In what situation is drum brake better than disc brake?

In case of cost..drum brake is better than disc brake.