i would go to your local reanault dealer
Wiki User
∙ 2009-12-16 20:48:58$325 on a 2005 suburban at my mechanics garage.
You can try disconnecting Neg--Black battery terminal for about 20 minutes..but that doesn't always work. It depends on what has engaged it, try another key or have key re-programmed to communicate with ECU.
That light is the failure indicator for the electronic throttle control system. If the light stays on, the engine computer will have stored a trouble code.That is the indicator for a failure in the electronic throttle system.
2005 rhino 660 value
Easy just hold down your power button until the light on the remote flashes. Then the TV will come on by it's self.(Note: if it does not work somethings wrong with your remote.)
How do you reset the brake pad warning light for a 2005 c320 mercedes benz?
The brake warning light on a 2005 BMW 325i can be reset by connecting an OBD II code reader. It can view and clear error codes detected by the computer.
Your Immobiliser needs to be reset basically.
The airbag light stays on when the computer has detected a malfunction and set a code. The light can not be reset until the failure is repaired.
As far as I know , once the tire is inflated to the correct pressure " range " and you drive the vehicle , after 1 minute the warning will reset itself
When you fill the tire that is showing low air pressure, after a few miles the sensor will reset itself.
how do you reset the check engine light on a 2005 Toyota tundra
fill all 5! tires to the proper pressure, even the spare will transmit and trip the light
How do i reset a service engine light on a 2005 gmc c6500 cat engine
Hi I have 2005 Toyota Matrix.I reset this " low tire pressure warning light."1. have your keys in ignition and turn to "ACC"do not have your engine start.2. push the reset button ( located lower left hand side of the steering wheel)( in Matrix it is middle one and the label same as the amber warning light.)keep it pressed for 10 seconds. ( amber light will flash and turn off)3. turn on and off the engine.This worked for me .
to reset the windows , with the ignition on hold the 2 front window switch`s up together for about 5 seconds and that should reset them ,,
NEVER reset ANY brake pad warning lights. It is ALWAYS safer to get a NEW set of pads. If your brakes fail, you may end up killing yourself or an innocent person. THIS is the best advice my friend