0
What else can I help you with?
How do you reset Pontiac Montana automatic door?
To reset the automatic doors on a Pontiac Montana, start by disconnecting the vehicle's battery for about 10 minutes to reset the system. After reconnecting the battery, open and close the doors manually to help recalibrate the automatic mechanism. If the doors still do not function properly, consult the owner's manual for specific troubleshooting steps or consider seeking assistance from a professional mechanic.
Where is the fuel reset switch for 2002 Pontiac Montana?
Pontiac does not use inertia/reset switches.
Where is the fuel switch located on a Pontiac Montana?
Not exactly sure what you're asking for here, but if you mean a fuel pump reset switch, as on a Ford, these vehicles are not equipped with it.
Where is the cut off switch located in a Pontiac Montana and how do you reset it?
I believe it is located under a panel on rear right of trunk.
How do you reset computer on 2006 pontiac montana van?
To reset the computer on a 2006 Pontiac Montana van, disconnect the negative battery cable and let it sit for about 15 minutes. This allows the system to clear any stored codes and reset the computer. Afterward, reconnect the negative battery cable and start the vehicle, which should reset the computer settings. If necessary, drive the van for a short while to allow the computer to recalibrate.
How do you reset the change oil light on Pontiac Montana 2006?
To reset the change oil light on a 2006 Pontiac Montana, first turn the ignition key to the "On" position without starting the engine. Then, press the accelerator pedal three times within five seconds. Finally, turn the ignition off and then back on to verify that the oil change light has been reset. If the light remains on, repeat the process.
How do you reset the computer on a 2001 Pontiac Montana Van?
To reset the computer on a 2001 Pontiac Montana Van, you can disconnect the negative battery cable for about 15 minutes to clear any stored error codes. After reconnecting the cable, turn the ignition to the "On" position without starting the engine for a few seconds. This allows the computer to reset. Finally, start the van and let it idle for a few minutes to allow the system to recalibrate.
Reset check engine light pontiac montana 2003?
To reset the check engine light on a 2003 Pontiac Montana, you can disconnect the negative battery terminal for about 10-15 minutes. This will clear the vehicle's computer memory and reset the light. Alternatively, you can use an OBD-II scanner to clear the codes directly. However, ensure that any underlying issues triggering the light are addressed to avoid future problems.
How do you reset the ABS indicator light in your 2001 Pontiac Montana?
I am still waiting for the answer u cant reset the abs light u have to take it to the shop, if your abs light is on there is something wrong with your trac system
Where is the fuel cut off switch located in a Pontiac Montana and how do you reset it?
I believe it is located under a panel on rear right of trunk.
Reseting the power sliding door gm Montana or venture show pictures?
To reset the power sliding door on a GM Montana or Venture, start by ensuring the vehicle is in gear and the ignition is on. Then, locate the power sliding door switch and press it to close the door fully, if it's partially open. If the door doesn't respond, you may need to disconnect the battery for a few minutes to reset the system. Unfortunately, I can't provide pictures, but you can find detailed instructions and images in the vehicle's owner manual or online forums.
Where is the reset full sistem butthom for Pontiac 1996?
where is the reset sistem buttomfor Pontiac 1996
