remove it
how do you remove the automatic transmission from the 2004 wrx.... i have everything disconnected except for the gearing fork shifter.
Remove transmission oil pan
See saturnfans.com
How do you remove the automatic shifter cablein a 1997 GMC sierra 1500
To replace the shifter bulb on a 1966 Mustang with an automatic transmission, first, remove the shifter bezel by gently prying it up. Then, locate the bulb socket underneath the shifter assembly, and twist it counterclockwise to remove it. Replace the old bulb with a new one, reinsert the socket, and then snap the bezel back into place. Ensure everything is secured and test the new bulb by turning on the vehicle's lights.
Yes you can remove a manual transmission and replace it with an automatic. You will need to buy an aftermarket shifter kit of find a shifter for your vehicle from a junk yard. You will also either have to remove the clutch pedal or replace the pedal assembly
If you have amanual transmission You have to push down on the plastic ring above the shifter boot. after you push down the ring, Now you can unscrew the shifter knob. IF you have a automatic transmission you have to remove the screw on the side of the shifter knob. (Be careful the button on the shifter knob is spring loaded)
Automatic or manual trans?
on my SL2 there is a clip on the side closest to the heater controls toward the bottom of the knob you either need to push it in or pull it out im pretty sure its like a horseshoe clip you pull out
To remove the shifter lever in a 2002 Mazda B3000 with an automatic transmission, first, ensure the vehicle is in park and disconnect the negative battery terminal. Remove the center console by unscrewing any visible screws and gently prying it up. Next, locate the retaining pin or bolt holding the shifter lever in place, remove it, and then lift the lever straight up to detach it from the transmission assembly. Reassemble the console and reconnect the battery once the installation is complete.
Remove shift release button off the top of the shifter, inside there is a small snap ring. Remove the snap ring and lift the shifter knob off.
remove access plate on floor around shifter, 4 bolts hold the shifter onto the trans.