answersLogoWhite

0


Best Answer

chain it to a concrete wall and drive as fast as you can in the opposite direction

User Avatar

Wiki User

13y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: How do you remove the rear axle shafts from a 2004 gmc safari?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Is there only one drive axle on a 94 dodge caravan?

there are axle shafts on the left and right fronts.there are axle shafts on the left and right fronts.


Does a 2005 Chrysler sebring have an u joint?

No the axle shafts use CV joints.No the axle shafts use CV joints.


What things have an universal joint in it?

Drive shafts, PTO shafts, Steering shafts, Axle shafts,


Where do you find universal joints in cars?

Drive shafts & axle shafts


Can you remove oil pan on 2004 Dakota with 5.9 v8?

Yes, if you remove the front axle first.Yes, if you remove the front axle first.


How do you change front axle seals on a 1999 Jeep Cherokee Sport?

You have to remove the brakes, rotors, wheel hubs, axle shafts, diff cover, and differential carrier, seals are on the inside of the axle tubes.


How do you remove front half shafts on a 1999 ford escort?

By removing the outer hub from the axle and you put a pry bar between the inner axle and the C clip holding it in. The axle is really in there so use a huge screwdriver or pry bar.


What do you-joints look like on a 98 Plymouth breeze?

It doesn't have universal joints. The axle shafts have constant velocity (CV) joints.It doesn't have universal joints. The axle shafts have constant velocity (CV) joints.


How do you replace right cv axle 2002 ford escape?

how to remove, or replace front right axle escape 2004


Dodge ram 95 1 ton 4x4 you are removing the front diff out of the axle housing and it is really stuck what is the easiest way to remove it?

After you have the axle shafts out, there is a special tool that spreads the axle housing about .020 inch to allow for diff carrier removal.


How do you tow a bus with heavy wrecker?

Run chains around the steer axle, put a support bar under the front frame rail so you don't rip the bumper off, remove the axle shafts, and book it.


How do you remove rear axles on Kubota rtv 900?

Jack the unit up and place jack stands under the frame. Drain your flluid. Remove rear wheels and hubs. The rear axles are actually 2 shafts slipped together. There is a plastic boot with a band at the top and bottom that must be removed. Use wire cutters to cut the bands. Once this is done to both sides, remove nuts holding the rear bumper/axle assembly in place. With the nuts removed the rear bumper/axle assembly can be rotated downward and side to side to release the shafts from each other, If you can not get them to release you may have to use a screwdriver to break the plastic boots free from the shafts. Once the rear bumper/axle housing is removed the outer shafts are pressed into the housing. The inner shafts are bolted to the transmission. All you need to do is remove these bolts and the inner half shaft will come out.