you have to take the front bumper off from underneath your car to get to the lights.
To clean the inside headlight lens on a ford ranger just simply remove the cap and clean.
Raise the hood. Remove the whole headlight unit. Nuts are reachable from inside. Not too difficult pc
The lenses are not removable from the headlights. They are one assembly.
It pulls off. Sometimes easier to remove the headlight assembly to change the bulb. We have instructions at our forum. www.trailvoy.com Trailblazer enthusiasts!
To remove the headlight housing (question is kind of vague, I have to assume this is what is being asked): Open hood & remove center grill. There are two bolts on each headlight housing on the inside, you will find them just behind where the grill was. Remove the two on the headlight housing you are trying to remove. Remove side marker light on the side you are removing the headlight from. You will find two nuts holding the headlight housing to the frame, remove them. Housing is now unbolted and can be slid out/off of the car.
The headlight on your 2008 Hyundai can be removed by removing the headlight retaining bolts from the inside of the engine compartment. Remove the wiring harness and replace with a new headlight.
I WA workin on my 98 contour last night and had to undo the headlight covers. if you want, i can email you a picture with my hand pointing to where the screws are to remove them. firstname.lastname@example.org
To remove the headlight housings on a 2003 350z first take the bumper off the car. Remove the wheel well covers to access the rear of the lights. Locate the four mounting bolts of the headlights and loosen them. Unplug and remove the housings.
With the hood open, remove the plastic cover the exposes the inside of the headlight. There are 3 clips to remove from the inside, plus the wire harness. The headlight just comes out from the out side then. You might have to replace some of the clips, only found at Ford, and about 7 bucks ea.
You have to remove the front bumper and remove the head lamp. then two plastic covers on the back of the assembly.