Depends on what year. Many, it's just a matter of removing screws and clips, then pulling it out. Some, you have to go into the dash.
You have to, from the inside of the van, remove the engine cover. Then all you have to do is remove the two flywing screws and lift the cover.
On top of the engine block. You'll need to remove the inside engine cover
you have to remove the flywheel, take engine cover off, remove flywheel, its under it, next to the points, you have to remove the flywheel, take engine cover off, remove flywheel, its under it, next to the points, you have to remove the flywheel, take engine cover off, remove flywheel, its under it, next to the points, you have to remove the flywheel, take engine cover off, remove flywheel, its under it, next to the points,
If I remember correctly the fuse box is located under the hood on the drive side of the engine. You have to remove the cover to exspose the fuses... the inside of the cover should identify the appropriate fuse.AnswerIf I remember correctly the fuse box is located under the hood on the drive side of the engine. You have to remove the cover to exspose the fuses... the inside of the cover should identify the appropriate fuse.
were is engine cover wot does it do
The 1995 Pontiac Grand Am 3.1 liter engine crank shaft sensor is located inside of the rear engine cover. You will need to remove the rear engine cover in order to access the crankshaft sensor.
It is located in the rear of the engine. You must remove the engine cover inside the cabin. The sensor is in the middle, back of the engine. Assuming the engine is in front of you. It requires a deep socket size 1-1/16 to remove sensor.
TFSI?
You have to remove the Engine Cover inside the Van. Two Larger Screws fasten the Engine Cover to the Firewall, near top of each side. Two Bolts Clamp the cover to the floor. You also have to remove the glove box storage unit. Two small screws and two nuts.
On top of the engine block. You'll need to remove that engine cover inside the van to get at it. It's in the big round cleaner assembly.
It depends on the model year and size of engine cover based on the engine underneath. For 1996 and newer, you generally have to remove the passenger seat in order to get the cover out of the way.
if your talking about the engine cover inside the van under the dash! on each Sid eof it back under the dash there are 2 latches on each side un latch them and carefully pull it out!