0
Add your answer:
Earn +20 pts
How do you replace the harmonic balancer on 2000 Infiniti I30?
how to replace harmonic balancer on a 2000 infiniti i30
How do you remove a harmonic balancer on a 2000 impala 3.8?
Take the serpentine belt off and then take the crankshaft pulley off and you will need a puller to get the balancer off the crank.
Where is the Camshaft Position Sensor on a 2000 Mercury Cougar located?
You will be able to find it right behind the harmonic balancer on the front of the engine at the bottom. .....................NO ITS NOT THAT IS THE CRANKSHAFT POSITION SENSOR....THEYRE ON THE HEADS ON THE BELT SIDE OF THE ENGINE....
Where is the harmonic balancer on a 2000 Chevy Silverado?
The front bottom PULLEY on the engine is bolted to the blancer.
What way do you turn the harmonic balancer bolt on a 2000 dodge neon?
Clockwise to tighten, counter to loosen.
Where is the Crankshaft sensor on a 2000 lesabre?
The 2000 Buick Regal 3.8L Crankshaft Position Sensor is located behind the harmonic balancer pulley.
Does a 2000 5.3 liter vortec have a keyway for the harmonic balancer or is it just pressed on and held by the new stretch bolt?
it has a key in it.
2000 Dodge Intrepid 2.7 liter is the harmonic balancer suppose to wobble back and forth towards the radiator?
yes when its broken!
How do you change the harmonic balancer on 2000 Malibu 3.1?
what do you need to take off car to get to c/shaft pulley on 2001 malibu
Where is the crank position sensor located on 2000 Mitsubishi Galant?
Behind harmonic balancer and timing belt on the 2.4 3.6-4 hrs
Where is the crankshaft sensor on a 2000 Dodge Durango?
Most crankshaft sensors are located above the harmonic balancer next to the timing chain cover . Good Luck Workin Man's Auto Repair ,Akron OhioMost crank sensors are above the harmonic balancer (front) or left of bell housing on the engine block (rear)
Where is the crank sensor for a 2000 Chevrolet 2500 located?
If it is a V8 then you will have to remove the starter to be able to see it. 1 Bolt holds it in place.The V6 will be on the passenger side of the front timing cover / Behind the harmonic balancer. 1 bolt holds it in place too.
