sometimes the cable isnt broke it just pulled out of its holder there only made of plastic if thats the case grab the cable with a pair of plyers and give it a good jurk remember theres two cables.. otherwise you need a long a hook about 2 ft long coat hanger mite work start at the middle of the windsheild and work towards the fender run the wire across the rubber seal careful not to rip it and try for the hook on the latch one side then the other it works when I got mine open I tied a thin wire to the latch and stuffed it under the hood near the wipers never have that trouble again
== ==
Ecklers has the replacement cable and "Installation instructions" which show how to get the hood open so you can relace the cable. Tried to attach the diagram, but no attachment tool here.
Mid-America Motorworks sells a tool for this.
This can be rather tuff........you must grab the hood release cable from the underside of the vehicle. Sometimes, you can trip open the hood latch with a long screwdriver, if you know where to do it.
you need to buy a hood opening lever and there is a hole on the left side of the dash on the end that touches the door use it in this hole and the hood will open
Mid-America Motorworks sells a Hood Opening Tool (part #609-637) for this. Instructions on how to use it are included. http://www.mamotorworks.com/corvette?frame 3.948
buy the special tool from ecklers that works thru the front of the door opening
crowbar
You can check in the Eckler's catalogue. I think there is a tool you can buy, kind of like a hook.
There's a special tool that'll release the latch by sticking it in between the hood edge and windshield. Any Corvette shop or even a dealer should have this. I've seen it advertised in Vette parts catalogs.
look if the cable breaks u can take a flat head and jam it where the hood is locked down and try to wiggle the release u need a long screw driver it took me 1 hour to do it but i got the job done!
HOW DO I OPEN HOOD ON CAR WHEN CABLE IS BROKEN