how do I open a door when the handle broke and the part theat connects into the outer wall will not release?
The usual reason that a door will not open from the inside on a Nissan truck is because the door handle is broken on the inside. The door panel will have to be removed and the door handle repaired or replaced to open the door from the inside again.
open it from the inside? actually i had the same problem. the handles themselves were not broken but the spring inside had come out of place and i had to bend it back so that it would push down far enough to open the door, also check the salvage yards.
the key lock in a ford 150 is broken how can the door be opened they broke into the truck be inserting something into the key hole how is this done
Bar from the handle to the latch is broken or disconnected.
crawl in from the trunk i do
Check the Actuator
the linkages to either the handles or the lock or both has come off. here's the kicker... you need to open the door to take of the inside door pannel to fix it. try to remove the pannel with the door closed. or a "skilled" vheicle locksmith could open it from the outside...but it's not cheap.
door open from inside or outside
It could be low on coolant, A stuck open thermostat, A broken/stuck blend door actuator.
To open a door on a 1998 Avenger that has a broken handle, a person might have to use another door to gain entry to the vehicle. Then the door can be opened from the inside.
You can use a "Jimmy" tool to open the door. The same way a Tow Truck Driver (or a thief) would do it. After you unlock the door with the Jimmy, use the Jimmy to reach the door handle and move it until it opens. Good luck!