Pull down on the plastic knob located on the front lower area of the grill.
Pull down on the black plastic knob that is located on the front lower area of the grill.
To remove the engine hood from a Massey Ferguson 60 HX, first, ensure the tractor is turned off and secure. Locate and remove any bolts or fasteners securing the hood, typically found near the front and sides. Carefully lift the hood off, taking care not to damage any attached components or wiring. If necessary, consult the owner's manual for specific instructions related to your model.
UNLOCK THE HOOD AT THE HINGES AND FLIP THE HOOD ALL THE WAY UP, THEN THE SPRINGS WILL COME RIGHT OUT
you might be able to get under the car somehow and flip the hood release from the inside.
Flip the left lever beside the steering wheel towards the hood
Under the hood on the left fender well under a black flip top fuse holder by the strut.
Anything is possible, but the Camaro and Firebird of those year had different hood designs, so the practical answer is no
look on passenger side, front fender. Should see a small red box, flip it open.
Hi,I assume that the bonnet is the same as the Connect and Focus?If it is, there is a lock on the bonnet/hood. Either behind the badge or the flip up panel
there are some under the dash on the right hand side under the flip down compartment and also some under the hood right next to the battery
Yes under the hood on the drivers side there's a little cap flip it up and that your positive plug and plug the negative on the engine block
go to the driver side door and look for the latch to open the hood. no need to open the hood, look above it and you will see a small door with a flip cover towards the back. open the door and connect the computer cable or what not.