0
Add your answer:
Earn +20 pts
Where is the crankshaft position sensor on a 96 Ford Probe SE?
"Where is the crankshaft position sensor on a 96 ford probe SE?"
Can an '89gt Ford Probe transmission go in a 1994 or'96 Ford Probe?
no, the 89-92 engine/transmissions are different from the 93-97 ford probe.
How do you install brake pads on a 96 Ford Probe gt?
dont try this at home
Can you remove the manual transmission out of 93 ford probe se and put in a 96 ford probe gt v6 manual transmission that's shot?
Negative......V6 uses different trans than I4
How fast will a stock 95 Ford Probe SE go?
It tops out at 118 mph. I have a 96 SE and love it.
Where is the OBD II connector on a 96 Ford Probe gt?
Next to the "Pop the hood" lever inside the car.
Where is heater blower relay on a 96 Ford Probe?
there are two on the right hand side of the engine bay. top corner.
Can you replace a 2.0 engine in a 95 probe with a 3.8 out of a 96 windstar?
The biggest engine you can fit in a probe is the engine out of the Ford Taurus SHO. I believe it is either 3.0 or 3.2 and requires a lot of modification to fit.
Where is the fuel filter located on a 96 Ford Probe GT?
Filter is mounted on the left side engine/transmission mount. Under the cruise control actuator.
Will a 87 ford ranger transmission fit into a 96 Mazda b2300?
What make and model ford 6 cyc will fit 96 mazda
How do i restart transmission computer for 96 Ford Probe gt?
You can restart the transmission computer, on your 1996 Ford, by removing the transmission, computer fuse. Keep the fuse out for 10 seconds and replace it to its original slot.
Will Pontiac sun fire rims fit a Ford Probe?
no sorry to say they want the bolt pattern is to small but a Toyota,jeep, ford ranger and some oldsmobiles will if you use Toyota or ford ranger rims you have to but a spacer or five washers on b4 you put on the rim to keep it off the calapers i have a 96 ford probe and i have some kind of ford rims on it and i had to but washers on and then the rims to keep it from rubbing
