john Deere 318 what oil in hydro does it take
1952 t0 1989
.18
Right side of engine on rear
91" long, 5/8 wide
Diagnostics needed for john deere f510 electrical system
probably the governor going bad
Not supposed to, the 318 was designed to have the 46 in or the 50 in deck on it. The 60 in decks mounting hardware that was used on the 420 is not the same. But if you can get it to work, good luck.
Yes it does. Most of the hoods from the John Deere tractors of that era are interchangeable. Here's a list of the hoods that will fit the 318: 200 series: 200, 208, 210, 212, 214, 216 Early 300 series: 300, 312, 314, 316 Kohler, 317 Late 300 series: 316 Onan, 318, 322, 330, 332 400 Series: 400, 420 The hoods for the 200 and early 300 series mowers are slightly different than the hoods for the late 300 series. They will all fit a 318, but the hood used for the late 300 series uses a different type of headlight lens than the hood on the 200 and early 300 series. The hood for the 200 and early 300's has a lens that just covers the front. The hood on the late 300's wraps around the front. Hope this helps!
No, it is not. A 2000RPM rear PTO shaft has a 1 inch by 15 spline yoke
mine has one on each side
23 gallons