0
Add your answer:
Earn +20 pts
How do you disable the seat belt alarm in a 2008 mondeo?
Ignition on (do not start motor) Buckle seatbelt 9 times and then unbuckle seatbelt Ignition off Seatbelt alarm is now disabled
2008 E350 seat belt alarm - how do you disable it?
Wear the seat Belt !
How do you disable the seat belt alarm on a 2008 f 150?
take out the fuse for it
How do you disable the air bag alarm in Mitsubishi pajero 2008?
the air bags of pajero 2012 is turn on . why?
How do you disable the seat belt alarm for the driver's side on a 2008 GMC Sierra?
Buckle your seat belt, works every time.
How do you disable the seat belt alarm on a 2008 suburban?
While it is possible to disable the alarm by going into the wiring of the vehicle, there areÊsimpler ways. You can purchase seat belt extenders and simply cut the ends off, or you could just buckle the seat belt before you sit in the seat.
How much did a 2008 Toyota hilux cost in el salvador 2008?
20,00
How do you disable the seat belt alarm in a 2008 cadillac?
under rear seat cushion there are fuses you can remove pass side push on seat lift up cushion
How do you disable abs in corolla?
How do you disable the abs on 2008 yaris
How do you disable the seat belt alarm on a 2008 Chevrolet Tahoe?
The easiest way I have found is buying a seat belt entender, or a seat belt buckle from a junk yard and insert it in female connector.
What are the ratings and certificates for Alarm - 2008?
Alarm - 2008 is rated/received certificates of: Ireland:15A
How do you disable the seat belt alarm for the 2008 mercury mariner?
You Can't. It is wired through the ignition system, Disable it car won't run. Safer to wear seatbelt. Wrong. All Ford products can have the Belt Minder disabled. Here is how you do it on the Mariner: Turn the ignition switch to on. Wait approximately 70 seconds for the seat belt light on the dash cluster to go out. For the seat belt you want to disable the minder on, insert and remove the belt approximately 10 times, you'll want to do it until you see the seat belt light turn on again. Then unbuckle the belt and the light will flash 4 times per second for a few seconds to confirm. This also works on F-150 pickups I know for sure, I just did it to confirm.
