Want this question answered?
There's a little door somewhere on the garage door opener--the unit hooked to the door itself, not the remote in your car. If you open the door you'll find a little plastic block that has switches on its face. That's where the code is set. Reset it to anything else, making sure to reset the switches in the remote, and the stolen remote will trouble you no further.
how do you clear codes on a 2001 Lincoln continental garage door opener
If you want to add a remote, press the "set" button on the power unit until the green light blinks, then press the button on the remote. If you want the unit to forget all old codes and accept only the new remote, hold the "set" button until the green light stays on solid, then press the remote button.
REMOTE codes
what are the codes for a sanyo universal remote
Garage door opener receivers internalize upto 10 different codes from 10 different transmitters. You may have reached your limit and must clear the memory to install the correct codes. If you have a Liftmaster, press the learn button on back/top right for 10 seconds then reprogram each transmitter then the keypad following manufactures instructions.
Close the garage door. Push the learn button on the back of the drive unit (receiver), light comes on. Hold down button on the remote opener (transmitter) and wait until light flashes on the drive unit and then it's programmed. I learned the hard way you cannot program a rolling code transmitter and a billion code transmitter to the same unit, what happens in this case is when you clear all the codes by holding down the learn button on the drive unit for 6+ seconds (which clears the codes), then do the programming sequence above for the remotes, (if you have 2 remotes and one is a billion and one is a rolling) only one will program at a time. Visit the Related Link for a one-page manual.
After performing checking procedures on any OBD-II components, clear the PCM of all trouble codes by disconnecting the negative cable from the remote battery terminal for at least ten seconds.
the codes for the bright star remote are 36C578TY
just type in remote codes in key word
what are the codes for a 47LG50 remote control to program DVD,VCR,Comcast
you can find it at any shop wherever you buy the remote. if there's no codes working for your remote maybe you should buy a new one that can get the codes working in it.