answersLogoWhite

0

use a vomm set to infinite resistance if you have reistance one way and not the other way. diode is good (must be isolated from circuit) if no resistance both directions diode D.O.A.

User Avatar

Wiki User

13y ago

What else can I help you with?

Related Questions

How do you check electronic diode?

you use an ohm meter


Is it possible to check diode and zener diode in laboratory?

yes, of course it is. one way is using a curve tracer.


What is a diode check setting used for on a dvom?

The Diode Check setting on a DVOM is a special ohms setting that presents enough voltage to the tested device to conduct, if it were a diode. Old style VOM's did not have this problem, because they usually used a battery greater than 0.7 volts to run the ohm's scale. Modern DVOM's, however, can use very small voltages to measure ohms, and that would not cause a diode to conduct. The Diode Check setting fixes this limitation.


What is the purpose is of a diode?

The purpose of a diode is to allow electric current to pass in one direction while blocking electric current in the opposite direction. It is for this reason that diode is usually referred as the check valve.


How does a diode work on an engine shutoff solenoid?

A diode is a one way check valve basically. it will let current pass one way but not the other.


Where is cam sensor 1998 Chrysler sebring 2.5?

It a non serviceable part of distributor.It a non serviceable part of distributor.


How is it possible to test a diode with a multimeter?

The diode must be isolated from any parallel current paths to test. check resistance both directions through diode. readings should show an open (or very high resistance) one direction and a short (or very low resistance) the other direction. Usually, a failed diode will show an open both directions. Set the multimeter to check resistance, attach each meter lead to opposite leads on diode, note reading, then swap meter leads and compare readings.


How to identify the anode and cathode of DR 25 diode?

The cathode of a diode is usually indicated with a band. In the absence of the band, consult the datasheet. Alternatively, use an ohmmeter that generates more than 0.7 volts at low current (a diode checker) and check conductance. The diode will conduct when the anode is more positive than the cathode.


Where do i sign up for sky broadband in US?

The best way is to visit their website and check if your area is serviceable or not. If yes, you can book an appointment from the website.


How is zener diode different from a conventional diode or ideal diode?

zener diode :zener diode operates under reverse bias voltageideal diode :ideal diode operates under forward bias voltage


Can a diode be used as rectifier diode?

yes, diode can be used as rectifier diode to convert ac to dc


Where is the coil on a 1996 Chrysler Sebring convertible 2.5 L?

It is a non serviceable part inside the distributor.It is a non serviceable part inside the distributor.