0
If you're asking how to change the condenser, it is under the rotor. Remove cap and rotor, remove condenser wire from contact set (either held in place with a screw or spring tension), remove the screw that holds the condenser bracket ( magnet or screw starter is very helpful), then reverse procedure to install new condenser.
What else can I help you with?
Where is the ignition condenser located on a 1976 Dodge D200?
Ignition condensers went out with the ignition points in the early 1970's.
Where is the ignition module on 1970 Chevy C10 with a 350 that has a HEI distributor?
under the rotor on the inside of the distributor cap
What is the ignition timing for a 1970 Chevy 454?
timing for the 454 engine is 10 degree's at TDC at 700 rpm in neutral or park
What is the best spark plug for a 1970 Chevy 350 engine?
ACDelco R45S conventional spark plugs for an original ignition system.
Change ignition lock on 1970 ford maverick?
How do I replace an Ignition in a 1970 Maverick
How do you replace a 1970 Chevy Nova ignition switch?
To replace the ignition switch in a 1970 Chevy Nova, first disconnect the battery to ensure safety. Remove the steering column cover by unscrewing any screws or bolts, then locate the ignition switch, which is usually mounted on the column. Detach the wiring harness from the old switch, unscrew it from its mounting position, and install the new switch in reverse order. Finally, reconnect the battery and test the new ignition switch to ensure it functions properly.
Ignition timing for a 1970 402 big block Chevy?
There are contributing factors, however, about 6 degrees advanced or BTDC., should work best.
When was MSD Ignition created?
MSD Ignition was created in 1970.
Will a 1970 Chevy camaro steering column fit a 1970 Chevy Chevelle?
No. not the same.
Why is your 1970 Chevy C-20 350 motor not getting spark?
1.Faulty ignition coil 2.Ignition points(if so equiped) are not opening or closing properly. 3.Faulty condenser 4. Interuption of voltage from primary ignition feed from starter switch. 5. Hot wire to batt. side of coil originating from hi-drain source such as starter terminal. 6.Faulty rotor,rotor cap, coil to rotor cap wire and or terminals.7. Moisture in cap and or terminals..........for starters.......no pun intended
What is the Weight of a 1970 Chevy Pick Up Truck?
what is the weight and length of a 1970 chevy shortbed truck?
How do you replace a 1970 Chevy ignition coil?
take the wires off the + and - side of the coil, pull the coil wire out of the coil, unbolt the coil from the manifold, to install just reverse directions.
