there are two screws that hold the rotor to the hub. be careful not to damage the screws.
its called a jack usually a scissor type jack is what comes with cars to change a tire
Lug nuts (or blots) are removable fasteners that hold the tire to the brake (or wheel) drum. Lug-nuts fasten to the bolts or studs that are fixed to the brake drum.
four screws hold the clear cover on take them out then five screws hold the gauges in take them out pull the gauges out the the bulbs are in the back
the battery is loacted behind the front tire on the driver's side. You have to jack up the car and remove the tire. Behind the tire is a compartment where the battery is located. There is a cover to the compartment. If I remember correctly, there are two screws that hold it on.
Firstly, use a Jack to lift the car up at the spot near the tyre you want to change. Secondly, unscrew the screws that hold the tyre in place. Make sure they do not roll away. Thirdly, remove the tyre and place it on the ground flat. This is not to let it roll away too. Fourthly, install the new tyre in the old tyre's place. Fifthly, screw the screws tightly to hold the tyre in place. Lastly, remove the Jack and make sure the tyre is not slanted.
You remove the screws that hold it in place.
remove the torx screws that hold in place, remove the bulbs from sockets
It should have screws that hold it in you take those screws out and the tail light should come off then you simply change the bulb
Remove the two screws that hold the lens on, remove the lens and change the bulbs.
Change the user display mode to show the Tire Pressure Monitor. Hold SET to reset
The spare tire is located in the trunk of the car. Open the trunk and you will find a panel on the right side. This panel has plastic screws on it. Take the screws out, and there it is.