First make sure the truck engine is cool.
Take the bolt off the high pressure hose, right on top of the Power Steering pump
You got to jack the truck up and may have to take the wheel off. Look inside the wheel
well and find the power steering rack. Should see the same bolt you did up top, it's
gonna be on tight. Make sure you have a drip pan ready. To put the new one on, start
at the bottom because it can be tricky to align up. Tighten the bolt at the top, then fill
up your power steering fluid. Start the truck, and then turn the wheel back and forth
for 2 minutes to get any air out of the line. That's it.
The first time, three hours; the second time, twenty five minutes.
The powersteering reservoir has the filler tube molded on/in it.
I Don't Know Sorry
The thermostat on a 1992 LeSabre should be inside of the top radiator hose inlet. You can easily change it by removing the top hose and water inlet.
only way to change lower radiator hose is to get underneath the vehicle there is a fawcet on bottom of radiator to dump coolant, then remove hose from underneath vehicle
Remove the belt from your 1992 Chevy Lumina power steering pump. Remove the power steering pump hose. Remove the power steering pump retaining bolts. Reverse the process to install the new power steering pump.
with a screwdriver and a pair of pliers
follow the radiator top hose back to engine the thermostat is there under that domed connection
remove top rad hose on motor and then the coolant flange the thermostat is under the flange
Loosen the dash and pull out the complete heater box after you have disconnected the heater hose from the firewall...........
how do replace a power steering hose on a Chevy c-1500 pickup truck
Depends on which hose you are talking about... There is a diagram under the hood of your truck that shows you the vacuum hose diagram.