0
Still curious? Ask our experts.
Chat with our AI personalities
Rafa
Devin
ReneAdd your answer:
Earn +20 pts
How do you change the door hinge pins and bushings on a 1994 GMC 1500 pickup truck?
How do you change the door hinge pins and bushings on a 2002 GMC 1500 pickup truck?"
How do you adjust GMC Denali headlights?
how do you adjust 2002 Denali headlights
How do you install new door pins and bushings on 2002 gmc Sonoma?
You replace the truck ...it comes with new hinge pins :((
How do you adjust drivers door to close properly on a 1998 gmc sierra extended cab?
If the door is sagging then you could look at the door pins and bushings. If the bushing is cracked then it will sag and therefore not close properly. If that is the case then the pins and bushings should cost under $10 and take about a half hour to do. Hope this helps.
Instructions to adjust the shifting cable on the steering column of a 1993 GMC Van 1500?
How to adjust the linkage on cable from steering column to transmission on a 1995 GMC Van?
How do you change door hinge pins a 1998 GMC Yukon?
go to youtube.com
What is the name of the truck of ironhide?
It is a GMC Top Kick 4x4
How do you adjust the rear parking brake on a 2002 GMC Sierra?
you dont adjust you replace brake shoes
How do you adjust timing on 1996 gmc 5.7?
You have to use a scanner.
How do you adjust clutch in a gmc c6500 with a cat 3126?
You cannot adjust the clutch on a newer gmc truck because they come with self adjusting clutches. If you have no free play at the top of the pedal you may have to adjust the linkage to give free play.
Can the carb on a 1995 gmc 1500 be adjusted?
The 1995 GMC 1500 is Fuel Injected and as such has no carburetor. Therefore there is nothing to adjust.
How do you adjust the doors on a 1999 GMC Sonoma or S10 truck?
I've worked for GM for over 10 years. Look at your door hinge pins and bushings first, they are probably wore out. To tell if the pins and bushings are worn out, open the door and lift up on it from the end opposite the hinges. If the door has any play at all the pins/bushings are worn. If you let them go too long the holes in the hinge wear the bushings sit can get wallered out.
