There's a small screw on top of the carburetor turn that and it should work I'm not positive I just saw that's what the mechanic did
engine will run but will not idle you could possibily block of both ends and adjust throtle body stop screw
The 1 bbl carb has 2 adjustments. The one by the accelerator linkage is for the idle control. The small one on the base plate is for air fuel adjustment. With the engine off turn the air fuel adjustment screw in until it stops. Do not tighten it only until it stops. Then back it out 1 to 1 and 1/2 turns out. That will get you a good starting point. Start the engine and adjust the air fuel screw in until the engine slows down. Then turn it out until it smooths out. That will get you close. Then adjust the Idle screw for the idle you want.
getting to much gas ,choking, or to little gas, adjust idle screw either way.Good luck
You'll need to provide your year, make and model but it could be that the idle isn't adjusted properly. Often this is just a matter of turning a screw but more info is needed to give a proper answer.
idle set too low, adjust the fuel to air mixture on a carb vehicle.if fuel injected, your injectors may need cleaned.Kadius1964~blog me.
The idle speed on a 1987 Chevy Celebrity is controlled by the engine computer, there is no way provided to adjust it.
You adjust idle with idle timing
Adjust idle on Mitsubishi diamante
Honda Accord 1998-2002 model GEN 6 idle speed is control by internal computer. You need to bring it to the dealer to adjust this.
carb problems, adjust the idle screw and see if that helps
how to adjust idle on 2001 legacy
you can adjust it via the idle control valve.
you cant adjust your idle, it is computer controlled
This question is not answerable without make model year and control system for the engine.
On the rear of the carb there should be a black plactic knob on a shaft with a spring. You will probably have to take the air cleaner housing off. Tightenen to idle up, loosen to idle down.
You do not adjust the Idle Air Control as it is controlled by the computor.
You dont adjust the Idle disconnect the battery for 10 mins and reconnect and the computer should relearn it idle .