answersLogoWhite

0

To check the oil in a Troy-Bilt weed eater, first ensure the engine is turned off and cool. Locate the oil fill cap, usually on the side of the engine, and remove it. Use a dipstick or wipe a clean cloth around the inside to check the oil level; it should be between the minimum and maximum marks. If the oil is low, add the appropriate type of oil until it reaches the correct level before replacing the cap.

User Avatar

AnswerBot

2mo ago

What else can I help you with?

Related Questions

How much oil does a tbp6040 xp troy built weed eater use?

none


How much oil does a troy built 4 cycle weed eater use?

3.4 fluid ounces


WHY Troy built weed eater bogs out at full throttle?

The exhaust could be plugged with carbon, carburetor has debris in it and needs to be cleaned, fouled spark plug


How do you remove spool on troy built weed eater?

To remove the spool from a Troy-Bilt weed eater, first, ensure the machine is turned off and unplugged (if applicable). Press the tabs on opposite sides of the spool to release it from the head. Once the tabs are pressed, gently pull the spool out of the trimmer head. If necessary, consult the user manual for specific instructions related to your model.


What is a compatible spark plug for 794 00082 in Troy bilt weed eater?

A compatible spark plug for the Troy-Bilt weed eater model with part number 794-00082 is the Champion RCJ-8Y. This spark plug is commonly used in many small engine applications and is known for its reliability and performance. Always ensure to check your owner's manual for specific recommendations and proper installation.


Oil for 4 cycle weed eater troy bilt?

Briggs and Sratton 30W oil available at Lowes or Home Depot.


My troy bilt weed eater won't start why?

There are several reasons your Troy-Bilt weed eater might not start. Common issues include a clogged fuel line or filter, stale fuel, a faulty spark plug, or a dirty air filter. Check these components, and ensure the fuel is fresh and mixed correctly if you’re using a two-stroke engine. If these don't resolve the problem, it may require professional servicing.


Where do you rid old weed eater?

You can get rid of an old weed eater at a recycling center. If you take the weed eater apart, you can get money for the metal.


How do you change oil on a 4 stroke troy bilt weed eater?

To change the oil on a 4-stroke Troy-Bilt weed eater, first ensure the engine is cool and then place the unit on a flat surface. Remove the oil fill cap and drain the old oil by tipping the weed eater slightly to allow the oil to flow out into a suitable container. Once drained, refill with fresh oil through the oil fill opening, using the recommended oil type as specified in the owner's manual. Replace the oil cap securely, and check the oil level to ensure it is within the recommended range.


When was Mister Weed-Eater created?

Mister Weed-Eater was created in 1993.


Why does your troy bilt weed eater only start with starter fluid?

check the muffler. usually there is a fine screen somewhere inside it to catch occasional sparks and this screen gets plugged with carbon and will not let the engine breath.


What is the gas to oil ratio for a Troy Built TB90BC weed and brush trimmer?

40:1