Use a high quality brand of automotive wax and grease remover.
you wash it
It depends on what you mean by clean. If you just have dirty powder coated railing, bicycle rack, etc. you can use soap and water.If you mean how do I clean it to be powder coated again there are a number of methods. You can sandblast it. Take it to a metal stripper. It can be burned off at about 800 degrees.Important note:Frequently, you can powder coat over previous powder coating by simply roughing up the surface with something like scotch brite or fine grit sand paper. You just want to give it a profile for the powder to bond to.
Hoppe's #9 and a tootbrush
Depending on what is effecting the look of the coat that will determine the best way to clean a women's shearling coat. For example, if the coat is not really dirty the woman can use cleaning spray and a cloth, or if the coat has stubborn dirt, a wire brush can get the dirt off. It is not recommended that shearling coats are tumbledried as this can take the 'life' out of the coat.
Denatured alcohol and a soft, clean, small cotton towel. Saturate one corner of the towel with alcohol, then using gentle motion to rub the glue off the paint. Depending on how large and how much glue, use a clean section of the towel each time you need to wet it with alcohol. This is safe for ALL vehicle finishes including clear coat. Do not drink the alcohol.
OXIE-CLEAN!
Cosmoline. Very difficult to clean off.
After you take it off, clean your nails with nail polish remover and then apply a clear coat of nail polish and then apply 'hand and nail' cream. After you take it off, clean your nails with nail polish remover and then apply a clear coat of nail polish and then apply 'hand and nail' cream.
Powder coat is pretty tough, but think 'ceramic' tough; if you scrape against a curb, yes, it will chip off.
Actully it's bad to bathe rabbits. It washes the oil from their skin and can dry it out besides they clean themseves. If you want to clean them off rub the coat with baby wipes to get off dirt or other things.
Best is a wire brush and baking soda. You can use grease to coat the terminals to slow down the corrosion.
The difference is foundation is what you put on after concealer. Now concealer is what covers up blemishes and dark circles. And then the powder is to finish it off and give it a nice clean cut look:)