I do work as a mechanic, but I have never worked on a Nissan so I am guessing on this. You probably have the same/similar problem. I just replaced the head gasket on my car, and I can't figure out the vacuum diagram. I bought a Chilton's Repair Manual thinking it would be in there, nope. I'm guessing it's just the small hoses since you said nothing about brakes. I also have a problem with the small ones, all of the larger ones pretty much atached themselves being as how there is only a few ways they can go.
no
they do
Nope. 240s only have a single and a dual cam motor both are fuel injected.
most 95 models come stock as obd1. the only obd2s are the later built models in the year. for example 95 240sx built in late october or november.
Pretty much, the 180sx is right side drive and 240sx is left. Other than that they are basically the same. I believe that some 180sx come with a CA18DE or the SR20DET, Im pretty sure that all 240sx come stock with a KA24E or KA24DE
Yes. ones with ABS and traction control come with a factory Vlsd
unfortunately not. Im assuming youre going to try to drift it and that's why youre asking. If you want a LSD then youll have to buy one or try and salvage one.
From the point at which you find Mira, follow these directions:Walk right until you come to a turning point.Walk downward until you come to a turning point.Walk a few paces right until you come to a turning point.Walk downward until you come to a turning point.Walk left until you come to a turning point.Walk downward until you come to a turning point.Walk left until you come to a turning point.Walk upward until you come to a turning point.Walk left until you come to a turning point.Walk upward until you come to a turning point.Walk a few paces left until you come to a turning point.Walk upward until you come to a turning point.Walk left until you come to a turning point.Walk upward until you come to a turning point.Walk left until you come to a turning point.Walk downward until you come to a turning point.Walk right until you come to a turning point.Walk downward until you come to a turning point.Walk right until you come to a turning point.Walk downward until you come to a turning point.Walk a few paces right until you come to a turning point.Walk downward. You should have come to the cave exit.
First fix the problem that caused the light to come on. Then you may be able to reset it by removing the battery cable for 5 minutes. If that does not work, you will need an OBD2 scan tool to reset the light.
The inspection light will come on when the engine is not operating properly. A check of the engine electronics is needed to find the problem that is turning the light on.
2003
A relay in the fusebox near the battery, its receives a signal from the ECU when to turn on